clk_pol should almost always be 1 (active-high pixel clock). When using the LDB, it must be 1 and for externally connected displays it should most probably also be 1. Original Freescale code sets this bit always, except when the FB_SYNC_CLK_LAT_FALL flag is set, which is a proprietary extension from Freescale that is not normally set. Signed-off-by: David Jander <david@xxxxxxxxxxx> --- drivers/gpu/drm/imx/ipuv3-crtc.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/gpu/drm/imx/ipuv3-crtc.c b/drivers/gpu/drm/imx/ipuv3-crtc.c index 7425fcc..97799ff 100644 --- a/drivers/gpu/drm/imx/ipuv3-crtc.c +++ b/drivers/gpu/drm/imx/ipuv3-crtc.c @@ -173,7 +173,7 @@ static int ipu_crtc_mode_set(struct drm_crtc *crtc, sig_cfg.clkflags = 0; sig_cfg.enable_pol = 1; - sig_cfg.clk_pol = 0; + sig_cfg.clk_pol = 1; sig_cfg.bus_format = ipu_crtc->bus_format; sig_cfg.v_to_h_sync = 0; sig_cfg.hsync_pin = ipu_crtc->di_hsync_pin; -- 2.1.4 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel
