Pingpong registers are needed by dsi command mode operation for tearing check. Split display registers are needed by dual dsi broadcast mode for synchronization. Signed-off-by: Hai Li <hali@xxxxxxxxxxxxxx> --- rnndb/mdp/mdp5.xml | 48 ++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 48 insertions(+) diff --git a/rnndb/mdp/mdp5.xml b/rnndb/mdp/mdp5.xml index 2e61e05..b4c90c7 100644 --- a/rnndb/mdp/mdp5.xml +++ b/rnndb/mdp/mdp5.xml @@ -172,6 +172,9 @@ xsi:schemaLocation="http://nouveau.freedesktop.org/ rules-ng.xsd"> <reg32 offset="0x0011C" name="HIST_INTR_EN"/> <reg32 offset="0x00120" name="HIST_INTR_STATUS"/> <reg32 offset="0x00124" name="HIST_INTR_CLEAR"/> + <reg32 offset="0x00128" name="SPARE_0"> + <bitfield name="SPLIT_DPL_SINGLE_FLUSH_EN" pos="0"/> + </reg32> <array offset="0x00180" name="SMP_ALLOC_W" length="8" stride="4"> <reg32 offset="0" name="REG" type="mdp5_smp_alloc"/> @@ -204,6 +207,19 @@ xsi:schemaLocation="http://nouveau.freedesktop.org/ rules-ng.xsd"> </array> </array> + <reg32 offset="0x003f4" name="SPLIT_DPL_EN"/> + <reg32 offset="0x003f8" name="SPLIT_DPL_UPPER"> + <bitfield name="SMART_PANEL" pos="1" type="boolean"/> + <bitfield name="SMART_PANEL_FREE_RUN" pos="2" type="boolean"/> + <bitfield name="INTF1_SW_TRG_MUX" pos="4" type="boolean"/> + <bitfield name="INTF2_SW_TRG_MUX" pos="8" type="boolean"/> + </reg32> + <reg32 offset="0x004f0" name="SPLIT_DPL_LOWER"> + <bitfield name="SMART_PANEL" pos="1" type="boolean"/> + <bitfield name="SMART_PANEL_FREE_RUN" pos="2" type="boolean"/> + <bitfield name="INTF1_TG_SYNC" pos="4" type="boolean"/> + <bitfield name="INTF2_TG_SYNC" pos="8" type="boolean"/> + </reg32> <!-- check length/index.. --> <array doffsets="mdp5_cfg->ctl.base[0],mdp5_cfg->ctl.base[1],mdp5_cfg->ctl.base[2],mdp5_cfg->ctl.base[3],mdp5_cfg->ctl.base[4]" name="CTL" length="5" stride="0x400"> <array offsets="0x000,0x004,0x008,0x00C,0x010,0x024" name="LAYER" length="6" stride="4"> @@ -412,6 +428,38 @@ xsi:schemaLocation="http://nouveau.freedesktop.org/ rules-ng.xsd"> <reg32 offset="0x2b0" name="GC_BASE"/> </array> + <array doffsets="mdp5_cfg->pp.base[0],mdp5_cfg->pp.base[1],mdp5_cfg->pp.base[2],mdp5_cfg->pp.base[3]" name="PP" length="4" stride="0x100"> + <reg32 offset="0x000" name="TEAR_CHECK_EN"/> + <reg32 offset="0x004" name="SYNC_CONFIG_VSYNC"> + <bitfield name="COUNT" low="0" high="18" type="uint"/> + <bitfield name="COUNTER_EN" pos="19" type="boolean"/> + <bitfield name="IN_EN" pos="20" type="boolean"/> + </reg32> + <reg32 offset="0x008" name="SYNC_CONFIG_HEIGHT"/> + <reg32 offset="0x00c" name="SYNC_WRCOUNT"> + <bitfield name="LINE_COUNT" low="0" high="15" type="uint"/> + <bitfield name="FRAME_COUNT" low="16" high="31" type="uint"/> + </reg32> + <reg32 offset="0x010" name="VSYNC_INIT_VAL"/> + <reg32 offset="0x014" name="INT_COUNT_VAL"> + <bitfield name="LINE_COUNT" low="0" high="15" type="uint"/> + <bitfield name="FRAME_COUNT" low="16" high="31" type="uint"/> + </reg32> + <reg32 offset="0x018" name="SYNC_THRESH"> + <bitfield name="START" low="0" high="15" type="uint"/> + <bitfield name="CONTINUE" low="16" high="31" type="uint"/> + </reg32> + <reg32 offset="0x01c" name="START_POS"/> + <reg32 offset="0x020" name="RD_PTR_IRQ"/> + <reg32 offset="0x024" name="WR_PTR_IRQ"/> + <reg32 offset="0x028" name="OUT_LINE_COUNT"/> + <reg32 offset="0x02c" name="PP_LINE_COUNT"/> + <reg32 offset="0x030" name="AUTOREFRESH_CONFIG"/> + <reg32 offset="0x034" name="FBC_MODE"/> + <reg32 offset="0x038" name="FBC_BUDGET_CTL"/> + <reg32 offset="0x03c" name="FBC_LOSSY_MODE"/> + </array> + <array doffsets="mdp5_cfg->intf.base[0],mdp5_cfg->intf.base[1],mdp5_cfg->intf.base[2],mdp5_cfg->intf.base[3],mdp5_cfg->intf.base[4]" name="INTF" length="5" stride="0x200"> <reg32 offset="0x000" name="TIMING_ENGINE_EN"/> <reg32 offset="0x004" name="CONFIG"/> -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by The Linux Foundation _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel
