From: Sean Paul <seanpaul@xxxxxxxxxxxx>
By paving the CTRL reg value, the current code changes MIPI_CAL_PRESCALE
("Auto-cal calibration step prescale") from 1us to 0.1us (val=0). In the
description for PHY's noise filter (MIPI_CAL_NOISE_FLT), the TRM states
that if the value of the prescale is 0 (or 0.1us), the filter should be
set between 2-5. However, the current code sets it to 0.
For now, let's keep the prescale and filter values as-is, which is most
likely the power-on-reset values of 0x2 and 0xa, respectively.
Signed-off-by: Sean Paul <seanpaul@xxxxxxxxxxxx>
Signed-off-by: Thierry Reding <treding@xxxxxxxxxx>
---
drivers/gpu/host1x/mipi.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/host1x/mipi.c b/drivers/gpu/host1x/mipi.c
index a3e215a0116f..0d8c3ae8db6a 100644
--- a/drivers/gpu/host1x/mipi.c
+++ b/drivers/gpu/host1x/mipi.c
@@ -208,7 +208,9 @@ int tegra_mipi_calibrate(struct tegra_mipi_device *device)
tegra_mipi_writel(device->mipi, value, modules[i].reg);
}
- tegra_mipi_writel(device->mipi, MIPI_CAL_CTRL_START, MIPI_CAL_CTRL);
+ value = tegra_mipi_readl(device->mipi, MIPI_CAL_CTRL);
+ value |= MIPI_CAL_CTRL_START;
+ tegra_mipi_writel(device->mipi, value, MIPI_CAL_CTRL);
err = tegra_mipi_wait(device->mipi);
--
2.1.2
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/dri-devel
