[PATCH 5/7] drm/exynos: fimd: modify I80 i/f interrupt relevant routine

[YoungJun Cho <yj44.cho@xxxxxxxxxxx>]

For the I80 interface, the video interrupt pending register(VIDINTCON1)
should be handled in fimd_irq_handler() and the video interrupt control
register(VIDINTCON0) should be handled in fimd_enable_vblank() and
fimd_disable_vblank() like RGB interface.
So this patch moves each set / unset routines into proper positions.
And adds triggering unset routine in fimd_trigger() to exit from it
because there is a case like set config which requires triggering
but vblank is not enabled.

Signed-off-by: YoungJun Cho <yj44.cho@xxxxxxxxxxx>
Acked-by: Inki Dae <inki.dae@xxxxxxxxxxx>
Acked-by: Kyungmin Park <kyungmin.park@xxxxxxxxxxx>
---
 drivers/gpu/drm/exynos/exynos_drm_fimd.c | 60 ++++++++++++++++++--------------
 1 file changed, 34 insertions(+), 26 deletions(-)

diff --git a/drivers/gpu/drm/exynos/exynos_drm_fimd.c b/drivers/gpu/drm/exynos/exynos_drm_fimd.c
index f062335..c949099 100644
--- a/drivers/gpu/drm/exynos/exynos_drm_fimd.c
+++ b/drivers/gpu/drm/exynos/exynos_drm_fimd.c
@@ -463,12 +463,19 @@ static int fimd_enable_vblank(struct exynos_drm_manager *mgr)
 		val = readl(ctx->regs + VIDINTCON0);
 
 		val |= VIDINTCON0_INT_ENABLE;
-		val |= VIDINTCON0_INT_FRAME;
 
-		val &= ~VIDINTCON0_FRAMESEL0_MASK;
-		val |= VIDINTCON0_FRAMESEL0_VSYNC;
-		val &= ~VIDINTCON0_FRAMESEL1_MASK;
-		val |= VIDINTCON0_FRAMESEL1_NONE;
+		if (ctx->i80_if) {
+			val |= VIDINTCON0_INT_I80IFDONE;
+			val |= VIDINTCON0_INT_SYSMAINCON;
+			val &= ~VIDINTCON0_INT_SYSSUBCON;
+		} else {
+			val |= VIDINTCON0_INT_FRAME;
+
+			val &= ~VIDINTCON0_FRAMESEL0_MASK;
+			val |= VIDINTCON0_FRAMESEL0_VSYNC;
+			val &= ~VIDINTCON0_FRAMESEL1_MASK;
+			val |= VIDINTCON0_FRAMESEL1_NONE;
+		}
 
 		writel(val, ctx->regs + VIDINTCON0);
 	}
@@ -487,9 +494,15 @@ static void fimd_disable_vblank(struct exynos_drm_manager *mgr)
 	if (test_and_clear_bit(0, &ctx->irq_flags)) {
 		val = readl(ctx->regs + VIDINTCON0);
 
-		val &= ~VIDINTCON0_INT_FRAME;
 		val &= ~VIDINTCON0_INT_ENABLE;
 
+		if (ctx->i80_if) {
+			val &= ~VIDINTCON0_INT_I80IFDONE;
+			val &= ~VIDINTCON0_INT_SYSMAINCON;
+			val &= ~VIDINTCON0_INT_SYSSUBCON;
+		} else
+			val &= ~VIDINTCON0_INT_FRAME;
+
 		writel(val, ctx->regs + VIDINTCON0);
 	}
 }
@@ -945,16 +958,19 @@ static void fimd_trigger(struct device *dev)
 	void *timing_base = ctx->regs + driver_data->timing_base;
 	u32 reg;
 
+	/* Enters triggering mode */
 	atomic_set(&ctx->triggering, 1);
 
-	reg = readl(ctx->regs + VIDINTCON0);
-	reg |= (VIDINTCON0_INT_ENABLE | VIDINTCON0_INT_I80IFDONE |
-						VIDINTCON0_INT_SYSMAINCON);
-	writel(reg, ctx->regs + VIDINTCON0);
-
 	reg = readl(timing_base + TRIGCON);
 	reg |= (TRGMODE_I80_RGB_ENABLE_I80 | SWTRGCMD_I80_RGB_ENABLE);
 	writel(reg, timing_base + TRIGCON);
+
+	/*
+	 * Exits triggering mode if vblank is not enabled yet, because when the
+	 * VIDINTCON0 register is not set, it can not exit from triggering mode.
+	 */
+	if (!test_bit(0, &ctx->irq_flags))
+		atomic_set(&ctx->triggering, 0);
 }
 
 static void fimd_te_handler(struct exynos_drm_manager *mgr)
@@ -966,9 +982,9 @@ static void fimd_te_handler(struct exynos_drm_manager *mgr)
 		return;
 
 	 /*
-	 * Skips to trigger if in triggering state, because multiple triggering
-	 * requests can cause panel reset.
-	 */
+	  * Skips triggering if in triggering mode, because multiple triggering
+	  * requests can cause panel reset.
+	  */
 	if (atomic_read(&ctx->triggering))
 		return;
 
@@ -1023,21 +1039,13 @@ static irqreturn_t fimd_irq_handler(int irq, void *dev_id)
 	if (ctx->pipe < 0 || !ctx->drm_dev)
 		goto out;
 
-	if (ctx->i80_if) {
-		/* unset I80 frame done interrupt */
-		val = readl(ctx->regs + VIDINTCON0);
-		val &= ~(VIDINTCON0_INT_I80IFDONE | VIDINTCON0_INT_SYSMAINCON);
-		writel(val, ctx->regs + VIDINTCON0);
+	drm_handle_vblank(ctx->drm_dev, ctx->pipe);
+	exynos_drm_crtc_finish_pageflip(ctx->drm_dev, ctx->pipe);
 
-		/* exit triggering mode */
+	if (ctx->i80_if) {
+		/* Exits triggering mode */
 		atomic_set(&ctx->triggering, 0);
-
-		drm_handle_vblank(ctx->drm_dev, ctx->pipe);
-		exynos_drm_crtc_finish_pageflip(ctx->drm_dev, ctx->pipe);
 	} else {
-		drm_handle_vblank(ctx->drm_dev, ctx->pipe);
-		exynos_drm_crtc_finish_pageflip(ctx->drm_dev, ctx->pipe);
-
 		/* set wait vsync event to zero and wake up queue. */
 		if (atomic_read(&ctx->wait_vsync_event)) {
 			atomic_set(&ctx->wait_vsync_event, 0);
-- 
1.9.0

_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/dri-devel