Instead of setting an initial value for the return code, set it explicitly
on each error path. This is just a cosmetic cleanup, as preparation for the
enable GPIO support.
Tested-by: Darren Etheridge <detheridge@xxxxxx>
Signed-off-by: Ezequiel Garcia <ezequiel@xxxxxxxxxxxxxxxxxxxx>
---
drivers/gpu/drm/tilcdc/tilcdc_panel.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/tilcdc/tilcdc_panel.c b/drivers/gpu/drm/tilcdc/tilcdc_panel.c
index 3dcf08e..f2a5b23 100644
--- a/drivers/gpu/drm/tilcdc/tilcdc_panel.c
+++ b/drivers/gpu/drm/tilcdc/tilcdc_panel.c
@@ -346,7 +346,7 @@ static int panel_probe(struct platform_device *pdev)
struct panel_module *panel_mod;
struct tilcdc_module *mod;
struct pinctrl *pinctrl;
- int ret = -EINVAL;
+ int ret;
/* bail out early if no DT data: */
if (!node) {
@@ -381,12 +381,14 @@ static int panel_probe(struct platform_device *pdev)
panel_mod->timings = of_get_display_timings(node);
if (!panel_mod->timings) {
dev_err(&pdev->dev, "could not get panel timings\n");
+ ret = -EINVAL;
goto fail_free;
}
panel_mod->info = of_get_panel_info(node);
if (!panel_mod->info) {
dev_err(&pdev->dev, "could not get panel info\n");
+ ret = -EINVAL;
goto fail_timings;
}
--
2.0.1
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/dri-devel
