Hi Boris Am Donnerstag, den 24.04.2014, 14:14 +0200 schrieb Boris BREZILLON: > Hi Tim, > > On 23/04/2014 17:36, Tim Niemeyer wrote: > > Hi Jean-Jacques, > > > > Am Freitag, den 18.04.2014, 11:45 +0200 schrieb Jean-Jacques Hiblot: > >> Hi, > >> > >> this patch serie implements a simple DRM driver for the ATMEL High end LCD > >> controller found in the SAMA5 familly. It's based on the tilcdc driver. > >> It uses the cma_helper for memory and fbdev stuff. > >> Your comments are welcome ! > > I applied your and Robert's patches on a 3.15-rc2 kernel and tried the > > framebuffer device on the sama5d31-ek. Seems to work. > > > >> Supported features: > >> * the base layer (the main framebuffer) > > Tested to show a little tux png, but it's appearing only after > > 'echo 0 > /sys/devices/ahb.1/apb.2/f0030000.hlcdc/graphics/fb0/rotate' > > is there missing some initializing? > > Could you try to apply this http://code.bulix.org/f01kvh-86117 ? I can't see any difference with that. I used fbv to display the tux. With CONFIG_FRAMEBUFFER_CONSOLE=n the display stays with a small atmel logo and u-Boot version information. If i set CONFIG_FRAMEBUFFER_CONSOLE=y, the display is black after kernel start and fbv just works as expected. Best Regards, Tim > Best Regards, > > Boris > > > > >> * a simple panel > >> * a backlight driver > > Tested to set brightness to 0, 20 and 255. Works. > > > > Thanks for your work. > > > > Best Regards > > Tim > > > >> * structure to 'easily' add other connectors (it comes from the tilcdc) > >> > >> On the todo list: > >> * support overlays as drm_planes > >> * support for the hardware cursor > >> * support for the SiI9022 HDMI connector (present on sama5d36ek) > >> > >> > >> Jean-Jacques Hiblot (3): > >> atmel: drm: added drm driver for the atmel hlcd controller > >> atmel: drm: dt: Added DT entry for the atmel hlcdc found in the sama5 > >> atmel: dt: Add supports for the lcdc support on the sama5d36ek > >> > >> arch/arm/boot/dts/sama5d36ek.dts | 27 +- > >> arch/arm/boot/dts/sama5d3_lcd.dtsi | 11 + > >> drivers/gpu/drm/Kconfig | 2 + > >> drivers/gpu/drm/Makefile | 1 + > >> drivers/gpu/drm/atmel_hlcdc/Kconfig | 13 + > >> drivers/gpu/drm/atmel_hlcdc/Makefile | 12 + > >> drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc.h | 771 +++++++++++++++++++++ > >> .../gpu/drm/atmel_hlcdc/atmel_hlcdc_backlight.c | 92 +++ > >> .../gpu/drm/atmel_hlcdc/atmel_hlcdc_backlight.h | 25 + > >> drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_crtc.c | 702 +++++++++++++++++++ > >> drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_drv.c | 586 ++++++++++++++++ > >> drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_drv.h | 124 ++++ > >> drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_ovl.h | 190 +++++ > >> drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_panel.c | 459 ++++++++++++ > >> drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_panel.h | 28 + > >> 15 files changed, 3042 insertions(+), 1 deletion(-) > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/Kconfig > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/Makefile > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc.h > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_backlight.c > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_backlight.h > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_crtc.c > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_drv.c > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_drv.h > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_ovl.h > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_panel.c > >> create mode 100644 drivers/gpu/drm/atmel_hlcdc/atmel_hlcdc_panel.h > >> > >> -- > >> 1.9.1 > >> > >> > >> _______________________________________________ > >> linux-arm-kernel mailing list > >> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx > >> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel > > > _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel
