Am Samstag, den 11.01.2014, 11:23 +0800 schrieb Shawn Guo:
> On Fri, Jan 10, 2014 at 03:22:24PM +0100, Philipp Zabel wrote:
> > Due to the voltage divider on the HPD line, the HDMI connector on
> > imx6q-sabrelite doesn't reliably detect connected DVI monitors.
> > This patch allows to use the RX_SENSE0 signal as a workaround when
> > enabled by a boolean device tree property 'hpd-unreliable'.
>
> If it's a fsl/imx specific property, it should have a 'fsl,' prefix.
> It should be added into binding doc. Oh, we do not even have a binding
> doc for this imx-hdmi yet.
Yes, We need to sort out the componentised DT bindings.
I don't think that this property is particularly i.MX specific, since
anybody could wire up their board in a way that the HDMI hotplug detect
pin doesn't work reliably with some DVI monitors.
regards
Philipp
> Shawn
>
> >
> > Signed-off-by: Philipp Zabel <p.zabel@xxxxxxxxxxxxxx>
> > ---
> > This patch is based on Russell's recent 46-patch imx-drm cleanup series.
> > Changes since v1:
> > - Store the status and polarity bits in struct imx_hdmi
> > ---
> > drivers/staging/imx-drm/imx-hdmi.c | 36 ++++++++++++++++++++++++++----------
> > 1 file changed, 26 insertions(+), 10 deletions(-)
> >
> > diff --git a/drivers/staging/imx-drm/imx-hdmi.c b/drivers/staging/imx-drm/imx-hdmi.c
> > index fb3177d..62cb531 100644
> > --- a/drivers/staging/imx-drm/imx-hdmi.c
> > +++ b/drivers/staging/imx-drm/imx-hdmi.c
> > @@ -140,6 +140,9 @@ struct imx_hdmi {
> > struct regmap *regmap;
> > struct i2c_adapter *ddc;
> > void __iomem *regs;
> > + u8 sink_detect_polarity;
> > + u8 sink_detect_status;
> > + u8 sink_detect_mask;
> >
> > unsigned int sample_rate;
> > int ratio;
> > @@ -1317,10 +1320,10 @@ static int imx_hdmi_fb_registered(struct imx_hdmi *hdmi)
> > HDMI_PHY_I2CM_CTLINT_ADDR);
> >
> > /* enable cable hot plug irq */
> > - hdmi_writeb(hdmi, (u8)~HDMI_PHY_HPD, HDMI_PHY_MASK0);
> > + hdmi_writeb(hdmi, hdmi->sink_detect_mask, HDMI_PHY_MASK0);
> >
> > /* Clear Hotplug interrupts */
> > - hdmi_writeb(hdmi, HDMI_IH_PHY_STAT0_HPD, HDMI_IH_PHY_STAT0);
> > + hdmi_writeb(hdmi, hdmi->sink_detect_status, HDMI_IH_PHY_STAT0);
> >
> > return 0;
> > }
> > @@ -1392,6 +1395,7 @@ static enum drm_connector_status imx_hdmi_connector_detect(struct drm_connector
> > {
> > struct imx_hdmi *hdmi = container_of(connector, struct imx_hdmi,
> > connector);
> > +
> > return hdmi->connector_status;
> > }
> >
> > @@ -1530,18 +1534,20 @@ static irqreturn_t imx_hdmi_irq(int irq, void *dev_id)
> >
> > phy_int_pol = hdmi_readb(hdmi, HDMI_PHY_POL0);
> >
> > - if (intr_stat & HDMI_IH_PHY_STAT0_HPD) {
> > - if (phy_int_pol & HDMI_PHY_HPD) {
> > + if (intr_stat & hdmi->sink_detect_status) {
> > + int pol_bit = hdmi->sink_detect_polarity;
> > +
> > + if (phy_int_pol & pol_bit) {
> > dev_dbg(hdmi->dev, "EVENT=plugin\n");
> >
> > - hdmi_modb(hdmi, 0, HDMI_PHY_HPD, HDMI_PHY_POL0);
> > + hdmi_modb(hdmi, 0, pol_bit, HDMI_PHY_POL0);
> >
> > hdmi->connector_status = connector_status_connected;
> > imx_hdmi_poweron(hdmi);
> > } else {
> > dev_dbg(hdmi->dev, "EVENT=plugout\n");
> >
> > - hdmi_modb(hdmi, HDMI_PHY_HPD, HDMI_PHY_HPD, HDMI_PHY_POL0);
> > + hdmi_modb(hdmi, pol_bit, pol_bit, HDMI_PHY_POL0);
> >
> > hdmi->connector_status = connector_status_disconnected;
> > imx_hdmi_poweroff(hdmi);
> > @@ -1550,7 +1556,7 @@ static irqreturn_t imx_hdmi_irq(int irq, void *dev_id)
> > }
> >
> > hdmi_writeb(hdmi, intr_stat, HDMI_IH_PHY_STAT0);
> > - hdmi_writeb(hdmi, ~HDMI_IH_PHY_STAT0_HPD, HDMI_IH_MUTE_PHY_STAT0);
> > + hdmi_writeb(hdmi, ~hdmi->sink_detect_status, HDMI_IH_MUTE_PHY_STAT0);
> >
> > return IRQ_HANDLED;
> > }
> > @@ -1702,14 +1708,24 @@ static int imx_hdmi_bind(struct device *dev, struct device *master, void *data)
> > */
> > hdmi_init_clk_regenerator(hdmi);
> >
> > + hdmi->sink_detect_status = HDMI_IH_PHY_STAT0_HPD;
> > + hdmi->sink_detect_polarity = HDMI_PHY_HPD;
> > + hdmi->sink_detect_mask = ~HDMI_PHY_HPD;
> > +
> > + if (of_property_read_bool(np, "hpd-unreliable")) {
> > + hdmi->sink_detect_status = HDMI_IH_PHY_STAT0_RX_SENSE0;
> > + hdmi->sink_detect_polarity = HDMI_PHY_RX_SENSE0;
> > + hdmi->sink_detect_mask = ~HDMI_PHY_RX_SENSE0;
> > + }
> > +
> > /*
> > * Configure registers related to HDMI interrupt
> > * generation before registering IRQ.
> > */
> > - hdmi_writeb(hdmi, HDMI_PHY_HPD, HDMI_PHY_POL0);
> > + hdmi_writeb(hdmi, hdmi->sink_detect_polarity, HDMI_PHY_POL0);
> >
> > /* Clear Hotplug interrupts */
> > - hdmi_writeb(hdmi, HDMI_IH_PHY_STAT0_HPD, HDMI_IH_PHY_STAT0);
> > + hdmi_writeb(hdmi, hdmi->sink_detect_status, HDMI_IH_PHY_STAT0);
> >
> > ret = imx_hdmi_fb_registered(hdmi);
> > if (ret)
> > @@ -1720,7 +1736,7 @@ static int imx_hdmi_bind(struct device *dev, struct device *master, void *data)
> > goto err_iahb;
> >
> > /* Unmute interrupts */
> > - hdmi_writeb(hdmi, ~HDMI_IH_PHY_STAT0_HPD, HDMI_IH_MUTE_PHY_STAT0);
> > + hdmi_writeb(hdmi, ~hdmi->sink_detect_status, HDMI_IH_MUTE_PHY_STAT0);
> >
> > ret = snd_dw_hdmi_probe(&hdmi->audio, dev, hdmi->regs, irq, hdmi);
> > if (ret)
> > --
> > 1.8.5.2
> >
>
>
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/dri-devel
