This series aims to enable display on the QCS615 platform 1.Add MDSS & DPU support for QCS615 2.Add DSI support for QCS615 QCS615 platform supports DisplayPort, and this feature will be added in a future patch Only dts part of this patch series depends on the following patch series The other dependency patches have already been merged into linux-next - dispcc https://lore.kernel.org/all/20241108-qcs615-mm-clockcontroller-v3-0-7d3b2d235fdf@xxxxxxxxxxx/ - dispcc dts https://lore.kernel.org/lkml/20241108-qcs615-mm-dt-nodes-v1-0-b2669cac0624@xxxxxxxxxxx/ Signed-off-by: Li Liu <quic_lliu6@xxxxxxxxxxx> Signed-off-by: Fange Zhang <quic_fangez@xxxxxxxxxxx> --- Changes in v4: - Add dp-connector node for anx_7625_out [Dmitry] - Add missing qcom,sm6150-dsi-ctrl for dsi-controller-main.yaml [Krzysztof] - Change VIG_SDM845_MASK to VIG_SDM845_MASK_SDMA for sm6150_sspp [Abhinav] - Change DMA_SDM845_MASK to DMA_SDM845_MASK_SDMA for sm6150_sspp [Abhinav] - Remove redundant annotation from sdm845_dsi_cfg [Dmitry] - Remove redundant blocks from sm6150_intf [Dmitry] - Update mdp_opp_table opp clk to correct value - Link to v3: https://lore.kernel.org/r/20241122-add-display-support-for-qcs615-platform-v3-0-35252e3a51fe@xxxxxxxxxxx Changes in v3: - Add reg_bus_bw for sm6150_data [Dmitry] - Remove patch for SX150X defconfig [Dmitry] - Remove dsi0_hpd_cfg_pins from ioexp [Dmitry] - Remove dsi0_cdet_cfg_pins from ioexpa [Dmitry] - Remove tlmm node for ioexp_intr_active and ioAexp_reset_active [Dmitry] - Remove qcs615_dsi_regulators and reuse sdm845_dsi_cfg [Dmitry, Konrad] - Rename qcs615/QCS615 to sm6150/SM6150 for whole patch [Dmitry] - Rename qcom,dsi-phy-14nm-615 to qcom,sm6150-dsi-phy-14nm [Dmitry] - Rename qcom,qcs615-dsi-ctrl to qcom,sm6150-dsi-ctrl [Dmitry] - Rename qcom,qcs615-dpu to qcom,sm6150-dpu [Dmitry] - Rename qcom,qcs615-mdss to qcom,sm6150-mdss [Dmitry] - Split drm dsi patch to dsi and dsi phy [Dmitry] - Update yaml clocks node with ephemeral nodes and remove unsed include [Dmitry, Rob] - Link to v2: https://lore.kernel.org/r/20241113-add-display-support-for-qcs615-platform-v2-0-2873eb6fb869@xxxxxxxxxxx Changes in v2: - Add QCS615 DP controller comment in commit message [Dmitry] - Add comments for dsi_dp_hpd_cfg_pins and dsi_dp_cdet_cfg_pins [Dmitry] - Add missing port@1 for connector for anx7625 [Dmitry] - Change 0 to QCOM_ICC_TAG_ALWAYS for mdss interconnects [Dmitry] - Change 0 to GPIO_ACTIVE_HIGH for GPIO flags [Dmitry] - Move anx_7625 to same node [Dmitry] - Move status to last in mdss_dsi0 [Dmitry] - Rename dsi0_hpd_cfg_pins to dsi_dp_hpd_cfg_pins in ioexp [Dmitry] - Rename dsi0_cdet_cfg_pins to dsi_dp_cdet_cfg_pins in ioexp [Dmitry] - Rename anx_7625_1 to dsi_anx_7625 in ioexp [Dmitry] - Remove absent block in qcs615_lm [Dmitry] - Remove merge_3d value in qcs615_pp [Dmitry] - Remove redundant annotation in qcs615_sspp [Dmitry] - Remove unsupported dsi clk from dsi0_opp_table [Dmitry] - Remove dp_hpd_cfg_pins node from ioexp [Dmitry] - Splite drm driver patches to mdss, dpu and dsi [Dmitry] - Link to v1: https://lore.kernel.org/r/20241014-add_display_support_for_qcs615-v1-0-4efa191dbdd4@xxxxxxxxxxx --- Li Liu (9): dt-bindings: display/msm: Add SM6150 DSI phy dt-bindings: display/msm: dsi-controller-main: Document SM6150 dt-bindings: display/msm: Add SM6150 MDSS & DPU drm/msm: mdss: Add SM6150 support drm/msm/dpu: Add SM6150 support drm/msm/dsi: Add dsi phy support for SM6150 drm/msm/dsi: Add support for SM6150 arm64: dts: qcom: Add display support for QCS615 arm64: dts: qcom: Add display support for QCS615 RIDE board .../bindings/display/msm/dsi-controller-main.yaml | 2 + .../bindings/display/msm/dsi-phy-14nm.yaml | 1 + .../bindings/display/msm/qcom,sm6150-dpu.yaml | 108 +++++++++ .../bindings/display/msm/qcom,sm6150-mdss.yaml | 245 ++++++++++++++++++++ arch/arm64/boot/dts/qcom/qcs615-ride.dts | 89 ++++++++ arch/arm64/boot/dts/qcom/qcs615.dtsi | 181 ++++++++++++++- .../gpu/drm/msm/disp/dpu1/catalog/dpu_5_3_sm6150.h | 254 +++++++++++++++++++++ drivers/gpu/drm/msm/disp/dpu1/dpu_hw_catalog.c | 1 + drivers/gpu/drm/msm/disp/dpu1/dpu_hw_catalog.h | 1 + drivers/gpu/drm/msm/disp/dpu1/dpu_kms.c | 1 + drivers/gpu/drm/msm/dsi/dsi_cfg.c | 2 + drivers/gpu/drm/msm/dsi/dsi_cfg.h | 1 + drivers/gpu/drm/msm/dsi/phy/dsi_phy.c | 2 + drivers/gpu/drm/msm/dsi/phy/dsi_phy.h | 1 + drivers/gpu/drm/msm/dsi/phy/dsi_phy_14nm.c | 21 ++ drivers/gpu/drm/msm/msm_mdss.c | 8 + 16 files changed, 917 insertions(+), 1 deletion(-) --- base-commit: 1031240d9d007339c6661dddfbe2efda0b3859e9 change-id: 20241209-add-display-support-for-qcs615-platform-22b8e8848f87 Best regards, -- fangez <quic_fangez@xxxxxxxxxxx>
