Hi Jyothi,
...
> @@ -523,26 +576,49 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg *msg,
> enum dma_transfer_direction dma_dirn;
> struct dma_async_tx_descriptor *desc;
> int ret;
> + struct gpi_multi_xfer *gi2c_gpi_xfer;
> + dma_cookie_t cookie;
>
> peripheral = config->peripheral_config;
> -
> - dma_buf = i2c_get_dma_safe_msg_buf(msg, 1);
> - if (!dma_buf)
> + gi2c_gpi_xfer = &peripheral->multi_xfer;
> + gi2c_gpi_xfer->msg_idx_cnt = cur_msg_idx;
> + dma_buf = gi2c_gpi_xfer->dma_buf[gi2c_gpi_xfer->buf_idx];
> + addr = gi2c_gpi_xfer->dma_addr[gi2c_gpi_xfer->buf_idx];
> +
> + dma_buf = i2c_get_dma_safe_msg_buf(&msgs[gi2c_gpi_xfer->msg_idx_cnt], 1);
> + if (!dma_buf) {
> + gi2c->err = -ENOMEM;
> return -ENOMEM;
> + }
>
> if (op == I2C_WRITE)
> map_dirn = DMA_TO_DEVICE;
> else
> map_dirn = DMA_FROM_DEVICE;
>
> - addr = dma_map_single(gi2c->se.dev->parent, dma_buf, msg->len, map_dirn);
> + addr = dma_map_single(gi2c->se.dev->parent,
> + dma_buf, msgs[gi2c_gpi_xfer->msg_idx_cnt].len,
You could save msgs[gi2c_gpi_xfer->msg_idx_cnt] in a separate
variable to avoid this extra indexing.
> + map_dirn);
> if (dma_mapping_error(gi2c->se.dev->parent, addr)) {
> - i2c_put_dma_safe_msg_buf(dma_buf, msg, false);
> + i2c_put_dma_safe_msg_buf(dma_buf, &msgs[gi2c_gpi_xfer->msg_idx_cnt],
> + false);
> + gi2c->err = -ENOMEM;
> return -ENOMEM;
> }
>
> + if (gi2c->is_tx_multi_xfer) {
> + if (((gi2c_gpi_xfer->msg_idx_cnt + 1) % NUM_MSGS_PER_IRQ))
> + peripheral->flags |= QCOM_GPI_BLOCK_EVENT_IRQ;
> + else
> + peripheral->flags &= ~QCOM_GPI_BLOCK_EVENT_IRQ;
> +
> + /* BEI bit to be cleared for last TRE */
> + if (gi2c_gpi_xfer->msg_idx_cnt == gi2c->num_msgs - 1)
> + peripheral->flags &= ~QCOM_GPI_BLOCK_EVENT_IRQ;
> + }
> +
> /* set the length as message for rx txn */
> - peripheral->rx_len = msg->len;
> + peripheral->rx_len = msgs[gi2c_gpi_xfer->msg_idx_cnt].len;
> peripheral->op = op;
>
> ret = dmaengine_slave_config(dma_chan, config);
> @@ -560,25 +636,56 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg *msg,
> else
> dma_dirn = DMA_DEV_TO_MEM;
>
> - desc = dmaengine_prep_slave_single(dma_chan, addr, msg->len, dma_dirn, flags);
> + desc = dmaengine_prep_slave_single(dma_chan, addr,
> + msgs[gi2c_gpi_xfer->msg_idx_cnt].len,
> + dma_dirn, flags);
> if (!desc) {
> dev_err(gi2c->se.dev, "prep_slave_sg failed\n");
> - ret = -EIO;
> + gi2c->err = -EIO;
> goto err_config;
> }
>
> desc->callback_result = i2c_gpi_cb_result;
> desc->callback_param = gi2c;
>
> - dmaengine_submit(desc);
> - *buf = dma_buf;
> - *dma_addr_p = addr;
> + if (!((msgs[cur_msg_idx].flags & I2C_M_RD) && op == I2C_WRITE)) {
> + gi2c_gpi_xfer->msg_idx_cnt++;
> + gi2c_gpi_xfer->buf_idx = (cur_msg_idx + 1) % QCOM_GPI_MAX_NUM_MSGS;
> + }
> + cookie = dmaengine_submit(desc);
> + if (dma_submit_error(cookie)) {
> + dev_err(gi2c->se.dev,
> + "%s: dmaengine_submit failed (%d)\n", __func__, cookie);
> + return -EINVAL;
goto err_config?
> + }
>
> + if (gi2c->is_tx_multi_xfer) {
> + dma_async_issue_pending(gi2c->tx_c);
> + if ((cur_msg_idx == (gi2c->num_msgs - 1)) ||
> + (gi2c_gpi_xfer->msg_idx_cnt >=
> + QCOM_GPI_MAX_NUM_MSGS + gi2c_gpi_xfer->freed_msg_cnt)) {
> + ret = gpi_multi_desc_process(gi2c->se.dev, gi2c_gpi_xfer,
> + gi2c->num_msgs, XFER_TIMEOUT,
> + &gi2c->done);
> + if (ret) {
> + dev_dbg(gi2c->se.dev,
> + "I2C multi write msg transfer timeout: %d\n",
> + ret);
if you are returning an error, then print an error.
> + gi2c->err = -ETIMEDOUT;
gi2c->err = ret?
> + goto err_config;
> + }
> + }
> + } else {
> + /* Non multi descriptor message transfer */
> + *buf = dma_buf;
> + *dma_addr_p = addr;
> + }
> return 0;
>
> err_config:
> - dma_unmap_single(gi2c->se.dev->parent, addr, msg->len, map_dirn);
> - i2c_put_dma_safe_msg_buf(dma_buf, msg, false);
> + dma_unmap_single(gi2c->se.dev->parent, addr,
> + msgs[cur_msg_idx].len, map_dirn);
> + i2c_put_dma_safe_msg_buf(dma_buf, &msgs[cur_msg_idx], false);
> return ret;
I would have one more label here:
out:
gi2c->err = ret;
return ret;
in order to avoid always assigning twice
> }
>
> @@ -590,6 +697,7 @@ static int geni_i2c_gpi_xfer(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[], i
> unsigned long time_left;
> dma_addr_t tx_addr, rx_addr;
> void *tx_buf = NULL, *rx_buf = NULL;
> + struct gpi_multi_xfer *tx_multi_xfer;
> const struct geni_i2c_clk_fld *itr = gi2c->clk_fld;
>
> config.peripheral_config = &peripheral;
> @@ -603,6 +711,39 @@ static int geni_i2c_gpi_xfer(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[], i
> peripheral.set_config = 1;
> peripheral.multi_msg = false;
>
> + gi2c->gpi_config = &peripheral;
> + gi2c->num_msgs = num;
> + gi2c->is_tx_multi_xfer = false;
> + gi2c->tx_irq_cnt = 0;
> +
> + tx_multi_xfer = &peripheral.multi_xfer;
> + tx_multi_xfer->msg_idx_cnt = 0;
> + tx_multi_xfer->buf_idx = 0;
> + tx_multi_xfer->unmap_msg_cnt = 0;
> + tx_multi_xfer->freed_msg_cnt = 0;
> + tx_multi_xfer->irq_msg_cnt = 0;
> + tx_multi_xfer->irq_cnt = 0;
you can initialize tx_multi_xfer to "{ };" to avoid all these
" = 0"
> +
> + /*
> + * If number of write messages are four and higher then
> + * configure hardware for multi descriptor transfers with BEI.
> + */
> + if (num >= MIN_NUM_OF_MSGS_MULTI_DESC) {
> + gi2c->is_tx_multi_xfer = true;
> + for (i = 0; i < num; i++) {
> + if (msgs[i].flags & I2C_M_RD) {
> + /*
> + * Multi descriptor transfer with BEI
> + * support is enabled for write transfers.
> + * Add BEI optimization support for read
> + * transfers later.
> + */
> + gi2c->is_tx_multi_xfer = false;
> + break;
> + }
> + }
> + }
> +
> for (i = 0; i < num; i++) {
> gi2c->cur = &msgs[i];
> gi2c->err = 0;
> @@ -613,14 +754,16 @@ static int geni_i2c_gpi_xfer(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[], i
> peripheral.stretch = 1;
>
> peripheral.addr = msgs[i].addr;
> + if (i > 0 && (!(msgs[i].flags & I2C_M_RD)))
> + peripheral.multi_msg = false;
>
> - ret = geni_i2c_gpi(gi2c, &msgs[i], &config,
> + ret = geni_i2c_gpi(gi2c, msgs, i, &config,
what is the point of passing 'i' if you always refer to msgs[i]
in geni_i2c_gpi()?
> &tx_addr, &tx_buf, I2C_WRITE, gi2c->tx_c);
> if (ret)
> goto err;
>
> if (msgs[i].flags & I2C_M_RD) {
> - ret = geni_i2c_gpi(gi2c, &msgs[i], &config,
> + ret = geni_i2c_gpi(gi2c, msgs, i, &config,
> &rx_addr, &rx_buf, I2C_READ, gi2c->rx_c);
> if (ret)
> goto err;
> @@ -628,18 +771,28 @@ static int geni_i2c_gpi_xfer(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[], i
> dma_async_issue_pending(gi2c->rx_c);
> }
>
> - dma_async_issue_pending(gi2c->tx_c);
> -
> - time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT);
> - if (!time_left)
> - gi2c->err = -ETIMEDOUT;
> + if (!gi2c->is_tx_multi_xfer) {
> + dma_async_issue_pending(gi2c->tx_c);
> + time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT);
> + if (!time_left) {
> + dev_err(gi2c->se.dev, "%s:I2C timeout\n", __func__);
> + gi2c->err = -ETIMEDOUT;
> + }
> + }
>
> if (gi2c->err) {
> ret = gi2c->err;
> goto err;
> }
>
> - geni_i2c_gpi_unmap(gi2c, &msgs[i], tx_buf, tx_addr, rx_buf, rx_addr);
> + if (!gi2c->is_tx_multi_xfer) {
> + geni_i2c_gpi_unmap(gi2c, &msgs[i], tx_buf, tx_addr, rx_buf, rx_addr);
> + } else {
> + if (gi2c->tx_irq_cnt != tx_multi_xfer->irq_cnt) {
else if (...) {
...
}
Andi
