On Thu, Oct 3, 2013 at 10:39 AM, Inki Dae <inki.dae@xxxxxxxxxxx> wrote: > 2013/10/3 Sean Paul <seanpaul@xxxxxxxxxxxx>: >> On Thu, Oct 3, 2013 at 9:55 AM, Inki Dae <inki.dae@xxxxxxxxxxx> wrote: >>> Can a regulator be used instead of gpio in other board case? >>> >> >> No, not to my knowledge. >> > > Hm.. plz check it out again. the gpio pin is specific to board, and > the the gpio be used as power source trigger could be replaced with a > regulator according to board design. So you should consider all > possibilities even though there are no other cases yet: other board > could use a regulator instead. Take a look at the data sheet, it is publicly available. PD_N is not a power supply input, so modelling it as a regulator makes no sense: "If PD_N is LOW, then the device is in Deep power-down completely, even if supply rail is ON; for the device to be able to operate, the PD_N pin must be HIGH." -Olof _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel
