The VFP, HBP, and HSA are divided between the available lanes if there is more than one lane. For certain timings and lane configurations, the HFP may not be evenly divisible. If the HFP is rounded down, it ends up being too small which can cause some monitors to not sync properly. In these instances, adjust htotal and hsync to round the HFP up, and recalculate the htotal. This allows 720P-60 to operation on an i.MX8MP with a four-lane configuration. Tested-by: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx> # Kontron BL i.MX8MM with HDMI monitor Signed-off-by: Adam Ford <aford173@xxxxxxxxx> --- V2: No changes V3: Remove the MIPI_DSI_MODE_VIDEO_SYNC_PULSE conditional as requested by Marek Vasut. Removed the Tested-by from Szyprowski because I don't know if removing the conditional will impact his boards. Update commit message diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c b/drivers/gpu/drm/bridge/samsung-dsim.c index 8476650c477c..e7e53a9e42af 100644 --- a/drivers/gpu/drm/bridge/samsung-dsim.c +++ b/drivers/gpu/drm/bridge/samsung-dsim.c @@ -1606,6 +1606,27 @@ static int samsung_dsim_atomic_check(struct drm_bridge *bridge, adjusted_mode->flags |= (DRM_MODE_FLAG_PHSYNC | DRM_MODE_FLAG_PVSYNC); } + /* + * When using video sync pulses, the HFP, HBP, and HSA are divided between + * the available lanes if there is more than one lane. For certain + * timings and lane configurations, the HFP may not be evenly divisible. + * If the HFP is rounded down, it ends up being too small which can cause + * some monitors to not sync properly. In these instances, adjust htotal + * and hsync to round the HFP up, and recalculate the htotal. Through trial + * and error, it appears that the HBP and HSA do not appearto need the same + * correction that HFP does. + */ + if (dsi->lanes > 1) { + int hfp = adjusted_mode->hsync_start - adjusted_mode->hdisplay; + int remainder = hfp % dsi->lanes; + + if (remainder) { + adjusted_mode->hsync_start += remainder; + adjusted_mode->hsync_end += remainder; + adjusted_mode->htotal += remainder; + } + } + return 0; } -- 2.43.0