Convert Samsung Exynos5250/5420 SoC Display Port Controller bindings to
DT schema with a change: add power-domains, already used in DTS.
This Display Port controller is actually variant of Analogix Display
Port bridge, however new DT Schema does not reference analogix,dp.yaml,
because of incompatibilities in the driver. The analogix,dp.yaml
expects two ports, input and output, but Linux Exynos DP DRM driver and
DTS use only one port: output.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
Changes in v2:
1. Document deprecated samsung,hpd-gpios
---
.../bindings/display/exynos/exynos_dp.txt | 112 ------------
.../display/samsung/samsung,exynos5-dp.yaml | 163 ++++++++++++++++++
2 files changed, 163 insertions(+), 112 deletions(-)
delete mode 100644 Documentation/devicetree/bindings/display/exynos/exynos_dp.txt
create mode 100644 Documentation/devicetree/bindings/display/samsung/samsung,exynos5-dp.yaml
diff --git a/Documentation/devicetree/bindings/display/exynos/exynos_dp.txt b/Documentation/devicetree/bindings/display/exynos/exynos_dp.txt
deleted file mode 100644
index 3a401590320f..000000000000
--- a/Documentation/devicetree/bindings/display/exynos/exynos_dp.txt
+++ /dev/null
@@ -1,112 +0,0 @@
-The Exynos display port interface should be configured based on
-the type of panel connected to it.
-
-We use two nodes:
- -dp-controller node
- -dptx-phy node(defined inside dp-controller node)
-
-For the DP-PHY initialization, we use the dptx-phy node.
-Required properties for dptx-phy: deprecated, use phys and phy-names
- -reg: deprecated
- Base address of DP PHY register.
- -samsung,enable-mask: deprecated
- The bit-mask used to enable/disable DP PHY.
-
-For the Panel initialization, we read data from dp-controller node.
-Required properties for dp-controller:
- -compatible:
- should be "samsung,exynos5-dp".
- -reg:
- physical base address of the controller and length
- of memory mapped region.
- -interrupts:
- interrupt combiner values.
- -clocks:
- from common clock binding: handle to dp clock.
- -clock-names:
- from common clock binding: Shall be "dp".
- -phys:
- from general PHY binding: the phandle for the PHY device.
- -phy-names:
- from general PHY binding: Should be "dp".
-
-Optional properties for dp-controller:
- -interlaced:
- interlace scan mode.
- Progressive if defined, Interlaced if not defined
- -vsync-active-high:
- VSYNC polarity configuration.
- High if defined, Low if not defined
- -hsync-active-high:
- HSYNC polarity configuration.
- High if defined, Low if not defined
- -samsung,hpd-gpio:
- Hotplug detect GPIO.
- Indicates which GPIO should be used for hotplug
- detection
- -video interfaces: Device node can contain video interface port
- nodes according to [1].
- - display-timings: timings for the connected panel as described by
- Documentation/devicetree/bindings/display/panel/display-timing.txt
-
-For the below properties, please refer to Analogix DP binding document:
- * Documentation/devicetree/bindings/display/bridge/analogix,dp.yaml
- -phys (required)
- -phy-names (required)
- -hpd-gpios (optional)
- force-hpd (optional)
-
-Deprecated properties for DisplayPort:
--interlaced: deprecated prop that can parsed from drm_display_mode.
--vsync-active-high: deprecated prop that can parsed from drm_display_mode.
--hsync-active-high: deprecated prop that can parsed from drm_display_mode.
--samsung,ycbcr-coeff: deprecated prop that can parsed from drm_display_mode.
--samsung,dynamic-range: deprecated prop that can parsed from drm_display_mode.
--samsung,color-space: deprecated prop that can parsed from drm_display_info.
--samsung,color-depth: deprecated prop that can parsed from drm_display_info.
--samsung,link-rate: deprecated prop that can reading from monitor by dpcd method.
--samsung,lane-count: deprecated prop that can reading from monitor by dpcd method.
--samsung,hpd-gpio: deprecated name for hpd-gpios.
-
--------------------------------------------------------------------------------
-
-Example:
-
-SOC specific portion:
- dp-controller {
- compatible = "samsung,exynos5-dp";
- reg = <0x145b0000 0x10000>;
- interrupts = <10 3>;
- interrupt-parent = <&combiner>;
- clocks = <&clock 342>;
- clock-names = "dp";
-
- phys = <&dp_phy>;
- phy-names = "dp";
- };
-
-Board Specific portion:
- dp-controller {
- display-timings {
- native-mode = <&lcd_timing>;
- lcd_timing: 1366x768 {
- clock-frequency = <70589280>;
- hactive = <1366>;
- vactive = <768>;
- hfront-porch = <40>;
- hback-porch = <40>;
- hsync-len = <32>;
- vback-porch = <10>;
- vfront-porch = <12>;
- vsync-len = <6>;
- };
- };
-
- ports {
- port@0 {
- dp_out: endpoint {
- remote-endpoint = <&bridge_in>;
- };
- };
- };
- };
diff --git a/Documentation/devicetree/bindings/display/samsung/samsung,exynos5-dp.yaml b/Documentation/devicetree/bindings/display/samsung/samsung,exynos5-dp.yaml
new file mode 100644
index 000000000000..dda9097a7911
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/samsung/samsung,exynos5-dp.yaml
@@ -0,0 +1,163 @@
+# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/display/samsung/samsung,exynos5-dp.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Samsung Exynos5250/Exynos5420 SoC Display Port
+
+maintainers:
+ - Inki Dae <inki.dae@xxxxxxxxxxx>
+ - Seung-Woo Kim <sw0312.kim@xxxxxxxxxxx>
+ - Kyungmin Park <kyungmin.park@xxxxxxxxxxx>
+ - Krzysztof Kozlowski <krzk@xxxxxxxxxx>
+
+properties:
+ compatible:
+ const: samsung,exynos5-dp
+
+ reg:
+ maxItems: 1
+
+ clocks:
+ maxItems: 1
+
+ clock-names:
+ items:
+ - const: dp
+
+ display-timings:
+ $ref: /schemas/display/panel/display-timings.yaml#
+
+ interrupts:
+ maxItems: 1
+
+ hpd-gpios:
+ description:
+ Hotplug detect GPIO.
+ Indicates which GPIO should be used for hotplug detection
+
+ phys:
+ maxItems: 1
+
+ phy-names:
+ items:
+ - const: dp
+
+ power-domains:
+ maxItems: 1
+
+ interlaced:
+ type: boolean
+ deprecated: true
+ description:
+ Interlace scan mode. Progressive if defined, interlaced if not defined.
+
+ vsync-active-high:
+ type: boolean
+ deprecated: true
+ description:
+ VSYNC polarity configuration. High if defined, low if not defined
+
+ hsync-active-high:
+ type: boolean
+ deprecated: true
+ description:
+ HSYNC polarity configuration. High if defined, low if not defined
+
+ ports:
+ $ref: /schemas/graph.yaml#/properties/ports
+
+ properties:
+ port:
+ $ref: /schemas/graph.yaml#/properties/port
+ description:
+ Port node with one endpoint connected to a dp-connector node.
+
+ required:
+ - port
+
+ samsung,hpd-gpios:
+ maxItems: 1
+ deprecated: true
+
+ samsung,ycbcr-coeff:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ deprecated: true
+ description:
+ Deprecated prop that can parsed from drm_display_mode.
+
+ samsung,dynamic-range:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ deprecated: true
+ description:
+ Deprecated prop that can parsed from drm_display_mode.
+
+ samsung,color-space:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ deprecated: true
+ description:
+ Deprecated prop that can parsed from drm_display_info.
+
+ samsung,color-depth:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ deprecated: true
+ description:
+ Deprecated prop that can parsed from drm_display_info.
+
+ samsung,link-rate:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ deprecated: true
+ description:
+ Deprecated prop that can reading from monitor by dpcd method.
+
+ samsung,lane-count:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ deprecated: true
+ description:
+ Deprecated prop that can reading from monitor by dpcd method.
+
+required:
+ - compatible
+ - reg
+ - clocks
+ - clock-names
+ - interrupts
+ - phys
+ - phy-names
+
+additionalProperties: false
+
+examples:
+ - |
+ #include <dt-bindings/clock/exynos5250.h>
+ #include <dt-bindings/gpio/gpio.h>
+ #include <dt-bindings/interrupt-controller/arm-gic.h>
+
+ dp-controller@145b0000 {
+ compatible = "samsung,exynos5-dp";
+ reg = <0x145b0000 0x1000>;
+ clocks = <&clock CLK_DP>;
+ clock-names = "dp";
+ interrupts = <10 3>;
+ interrupt-parent = <&combiner>;
+ phys = <&dp_phy>;
+ phy-names = "dp";
+ pinctrl-0 = <&dp_hpd>;
+ pinctrl-names = "default";
+ power-domains = <&pd_disp1>;
+
+ samsung,color-space = <0>;
+ samsung,color-depth = <1>;
+ samsung,link-rate = <0x0a>;
+ samsung,lane-count = <2>;
+ hpd-gpios = <&gpx0 7 GPIO_ACTIVE_HIGH>;
+
+ ports {
+ port {
+ dp_out: endpoint {
+ remote-endpoint = <&bridge_in>;
+ };
+ };
+ };
+ };
--
2.34.1
