From: Werner Sembach <wse@xxxxxxxxxxxxxxxxxxx> Remove unnecessary SIGNAL_TYPE_HDMI_TYPE_A check that was performed in the drm_mode_is_420_only() case, but not in the drm_mode_is_420_also() && force_yuv420_output case. Without further knowledge if YCbCr 4:2:0 is supported outside of HDMI, there is no reason to use RGB when the display reports drm_mode_is_420_only() even on a non HDMI connection. This patch also moves both checks in the same if-case. This eliminates an extra else-if-case. Signed-off-by: Werner Sembach <wse@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Andri Yngvason <andri@xxxxxxxxxxx> Tested-by: Andri Yngvason <andri@xxxxxxxxxxx> --- drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c | 6 +----- 1 file changed, 1 insertion(+), 5 deletions(-) diff --git a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c index f6575d7dee971..cc4d1f7f97b98 100644 --- a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c +++ b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c @@ -5575,11 +5575,7 @@ static void fill_stream_properties_from_drm_display_mode( timing_out->v_border_bottom = 0; /* TODO: un-hardcode */ if (drm_mode_is_420_only(info, mode_in) - && stream->signal == SIGNAL_TYPE_HDMI_TYPE_A) - timing_out->pixel_encoding = PIXEL_ENCODING_YCBCR420; - else if (drm_mode_is_420_also(info, mode_in) - && aconnector - && aconnector->force_yuv420_output) + || (drm_mode_is_420_also(info, mode_in) && aconnector->force_yuv420_output)) timing_out->pixel_encoding = PIXEL_ENCODING_YCBCR420; else if ((connector->display_info.color_formats & DRM_COLOR_FORMAT_YCBCR444) && stream->signal == SIGNAL_TYPE_HDMI_TYPE_A) -- 2.43.0
