Re: [PATCH v7 10/12] drm/bridge: Implement enable_next_first to alter bridge init order

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Jagan

On Thu, 30 Mar 2023 at 07:56, Jagan Teki <jagan@xxxxxxxxxxxxxxxxxxxx> wrote:
>
> On Wed, Mar 29, 2023 at 10:16 PM Maxime Ripard <maxime@xxxxxxxxxx> wrote:
> >
> > On Wed, Mar 29, 2023 at 05:28:28PM +0100, Dave Stevenson wrote:
> > > On Wed, 29 Mar 2023 at 14:19, Jagan Teki <jagan@xxxxxxxxxxxxxxxxxxxx> wrote:
> > > >
> > > > DSI sink devices typically send the MIPI-DCS commands to the DSI host
> > > > via general MIPI_DSI_DCS read and write API.
> > > >
> > > > The classical DSI sequence mentioned that the DSI host receives MIPI-DCS
> > > > commands from the DSI sink first in order to switch HS mode properly.
> > > > Once the DSI host switches to HS mode any MIPI-DCS commands from the
> > > > DSI sink are unfunctional.
> > >
> > > That statement contradicts the spec.
> > > The DSI spec section 8.11.1 Transmission Packet Sequences says that
> > > during any BLLP (Blanking or Low Power) period the host can do any of:
> > > - remain in LP-11
> > > - transmit one or more non-video packets from host to peripheral in escape mode
> > > - transmit one or more non-video packets from host to peripheral in
> > > using HS mode
> > > - receive one or more packets from peripheral to host using escape mode
> > > - transmit data on a different virtual channel.
> > >
> > > Indeed if the sink doesn't set MIPI_DSI_MODE_LPM /
> > > MIPI_DSI_MSG_USE_LPM, then the expectation is that any data transfer
> > > will be in HS mode.
> > >
> > > That makes me confused as to the need for this patch.
> >
> > Yeah, and it looks like that would break the expectation that, in
> > enable, a bridge can expect its controller to be in HS mode.
> >
> > I think that was Jagan is trying to do is to work around an issue with
> > the Allwinner DSI driver:
> > https://elixir.bootlin.com/linux/v6.3-rc4/source/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c#L775
>
> Correct and I can see it seems to be a classic DSI sequence observed
> in dw-mipi-dsi as well - based on Neil's comments.
> https://lore.kernel.org/all/9aa3d19d-4378-aaf3-6857-c40be5d252c7@xxxxxxxxxxxx/

Neil's comments are from 2021, and his response would appear to be
with regard the PHY power up sequence issues that
pre_enable_prev_first should solve. The DSI host pre_enable can now be
called before the sink's pre_enable, therefore allowing the PHY to be
configured in pre_enable. Hacking the PHY init into mode_set is
therefore not required.

I don't see any restriction in dw-mipi-dsi over when transfer can be
called (as long as it is between pre_enable and post_disable), and it
supports MIPI_DSI_MSG_USE_LPM for requesting the command be sent in
either LP or HS mode.

> In fact, I did follow and initialize the command-mode mode_set which
> set low-speed DCS and switch back to video-mode @enable and switch to
> HS but could see the same issue as the host cannot accept DCS as
> before (I might implement improper sequence, but not sure due to lack
> of documentation). But this sequence has issues with calling
> post_disable twice even on dw-mipi-dsi.

Calling up/down the bridge chain from within other bridge elements is
going to have issues and shouldn't be necessary.

The comment in dw-mipi-dsi post_disable[1]
* TODO Only way found to call panel-bridge post_disable &
* panel unprepare before the dsi "final" disable...
* This needs to be fixed in the drm_bridge framework and the API
* needs to be updated to manage our own call chains...

It has now been fixed up with pre_enable_prev_first.

I seem to recall seeing a patchset for one of the DSI hosts (other
than vc4) that was moving the init from mode_set to pre_enable - I
think it is probably [2] for msm.

Cheers
  Dave

[1] https://github.com/torvalds/linux/blob/master/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c#L862-L867
[2] https://github.com/torvalds/linux/commit/ec7981e6c614254937b37ce0af9eac09901c05c5

> May be Neill, can comment here?
>
> Thanks,
> Jagan.




[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux