On Mi, 2022-04-06 at 18:01 +0200, Lucas Stach wrote:
> This IP block is found in the HDMI subsystem of the i.MX8MP SoC. It has a
> full timing generator and can switch between different video sources. On
> the i.MX8MP however the only supported source is the LCDIF. The block
> just needs to be powered up and told about the polarity of the video
> sync signals to act in bypass mode.
>
> Signed-off-by: Lucas Stach <l.stach@xxxxxxxxxxxxxx>
> ---
[...]
> +static void imx_hdmi_pvi_bridge_enable(struct drm_bridge *bridge,
> + struct drm_bridge_state *bridge_state)
> +{
> + struct drm_atomic_state *state = bridge_state->base.state;
> + struct imx_hdmi_pvi *pvi = to_imx_hdmi_pvi(bridge);
> + struct drm_connector_state *conn_state;
> + const struct drm_display_mode *mode;
> + struct drm_crtc_state *crtc_state;
> + struct drm_connector *connector;
> + u32 bus_flags, val;
> +
> + connector = drm_atomic_get_new_connector_for_encoder(state, bridge->encoder);
> + if (WARN_ON(!connector))
> + return;
> +
> + conn_state = drm_atomic_get_new_connector_state(state, connector);
> + if (WARN_ON(!conn_state))
> + return;
> +
> + crtc_state = drm_atomic_get_new_crtc_state(state, conn_state->crtc);
> + if (WARN_ON(!crtc_state))
> + return;
Can those happen at all, and if so, should they be caught at
atomic_check time?
> +
> + if (WARN_ON(pm_runtime_resume_and_get(pvi->dev)))
> + return;
Should be pm_runtime_get_sync(), since the error is ignored.
Otherwise the pm_runtime_put() in imx_hdmi_pvi_bridge_disable() will
double-decrement the usage counter in case this failed.
regards
Philipp
