The nouveau KMS driver will call drm_plane_create_zpos_property() with an init value depending on the plane purpose. Since the initial value wasn't carried over in the state, the driver had to set it again in nv50_wndw_reset(). However, the helpers have been adjusted to set it properly at reset, so this is not needed anymore. Cc: nouveau@xxxxxxxxxxxxxxxxxxxxx Cc: Ben Skeggs <bskeggs@xxxxxxxxxx> Cc: Karol Herbst <kherbst@xxxxxxxxxx> Cc: Lyude Paul <lyude@xxxxxxxxxx> Signed-off-by: Maxime Ripard <maxime@xxxxxxxxxx> --- drivers/gpu/drm/nouveau/dispnv50/wndw.c | 2 -- 1 file changed, 2 deletions(-) diff --git a/drivers/gpu/drm/nouveau/dispnv50/wndw.c b/drivers/gpu/drm/nouveau/dispnv50/wndw.c index 133c8736426a..0c1a2ea0ed04 100644 --- a/drivers/gpu/drm/nouveau/dispnv50/wndw.c +++ b/drivers/gpu/drm/nouveau/dispnv50/wndw.c @@ -635,8 +635,6 @@ nv50_wndw_reset(struct drm_plane *plane) plane->funcs->atomic_destroy_state(plane, plane->state); __drm_atomic_helper_plane_reset(plane, &asyw->state); - plane->state->zpos = nv50_wndw_zpos_default(plane); - plane->state->normalized_zpos = nv50_wndw_zpos_default(plane); } static void -- 2.35.1
