The omap KMS driver will call drm_plane_create_zpos_property() with an init value of the plane index and the plane type. Since the initial value wasn't carried over in the state, the driver had to set it again in omap_plane_reset(). However, the helpers have been adjusted to set it properly at reset, so this is not needed anymore. Reviewed-by: Tomi Valkeinen <tomba@xxxxxxxxxx> Signed-off-by: Maxime Ripard <maxime@xxxxxxxxxx> --- drivers/gpu/drm/omapdrm/omap_plane.c | 7 ------- 1 file changed, 7 deletions(-) diff --git a/drivers/gpu/drm/omapdrm/omap_plane.c b/drivers/gpu/drm/omapdrm/omap_plane.c index e67baf9a942c..d96bc929072a 100644 --- a/drivers/gpu/drm/omapdrm/omap_plane.c +++ b/drivers/gpu/drm/omapdrm/omap_plane.c @@ -414,13 +414,6 @@ static void omap_plane_reset(struct drm_plane *plane) return; __drm_atomic_helper_plane_reset(plane, &omap_state->base); - - /* - * Set the zpos default depending on whether we are a primary or overlay - * plane. - */ - plane->state->zpos = plane->type == DRM_PLANE_TYPE_PRIMARY - ? 0 : omap_plane->id; plane->state->color_encoding = DRM_COLOR_YCBCR_BT601; plane->state->color_range = DRM_COLOR_YCBCR_FULL_RANGE; } -- 2.35.1
