Hi Linus. On Mon, Jul 20, 2020 at 10:35:05PM +0200, Linus Walleij wrote: > This adds device tree bindings for the Kinetic KTD253 > white LED backlight driver. > > Cc: devicetree@xxxxxxxxxxxxxxx > Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx> See a few comments in the following. Sam > --- > .../leds/backlight/kinetic,ktd253.yaml | 48 +++++++++++++++++++ > 1 file changed, 48 insertions(+) > create mode 100644 Documentation/devicetree/bindings/leds/backlight/kinetic,ktd253.yaml > > diff --git a/Documentation/devicetree/bindings/leds/backlight/kinetic,ktd253.yaml b/Documentation/devicetree/bindings/leds/backlight/kinetic,ktd253.yaml > new file mode 100644 > index 000000000000..610bf9a0e270 > --- /dev/null > +++ b/Documentation/devicetree/bindings/leds/backlight/kinetic,ktd253.yaml > @@ -0,0 +1,48 @@ > +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/leds/backlight/kinetic,ktd253.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: Kinetic Technologies KTD253 one-wire backlight > + > +maintainers: > + - Linus Walleij <linus.walleij@xxxxxxxxxx> > + > +description: | > + The Kinetic Technologies KTD253 is a white LED backlight that is > + controlled by a single GPIO line. If you just turn on the backlight > + it goes to maximum backlight then you can set the level of backlight > + using pulses on the enable wire. No $ref for common.yaml? > + > +properties: > + compatible: > + const: kinetic,ktd253 > + > + gpios: A less generic and more descriptive name would be good. > + description: GPIO to use to enable/disable and dim the backlight. > + maxItems: 1 > + > + default-brightness: > + description: Default brightness level on boot. 0 is off. > + minimum: 0 > + maximum: 255 > + > + max-brightness: > + description: Maximum brightness that is allowed during runtime. > + minimum: 0 > + maximum: 255 Both looks like candidates for common.yaml - they are used by other bindings. > + > +required: > + - compatible > + - gpios It would make senste that maximum-brighness was mandatory too. addtionalProperties: false?? > + > +examples: > + - | > + #include <dt-bindings/gpio/gpio.h> > + backlight { > + compatible = "kinetic,ktd253"; > + gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; > + default-on; default-on is not documented - and not part of common.yaml. > + default-brightness = <160>; > + }; > -- > 2.26.2 > > _______________________________________________ > dri-devel mailing list > dri-devel@xxxxxxxxxxxxxxxxxxxxx > https://lists.freedesktop.org/mailman/listinfo/dri-devel _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
