Change the method of frame rate calc which can get more accurate frame rate. data rate = pixel_clock * bit_per_pixel / lanes Adjust hfp_wc to adapt the additional phy_data if MIPI_DSI_MODE_VIDEO_BURST hfp_wc = hfp * bpp - data_phy_cycles * lanes - 12 - 6; else hfp_wc = hfp * bpp - data_phy_cycles * lanes - 12; Note: //(2: 1 for sync, 1 for phy idle) data_phy_cycles = T_hs_exit + T_lpx + T_hs_prepare + T_hs_zero + 2; bpp: bit per pixel Signed-off-by: Jitao Shi <jitao.shi@xxxxxxxxxxxx> Tested-by: Ryan Case <ryandcase@xxxxxxxxxxxx> --- drivers/gpu/drm/mediatek/mtk_dsi.c | 118 ++++++++++++++++++++--------- 1 file changed, 81 insertions(+), 37 deletions(-) diff --git a/drivers/gpu/drm/mediatek/mtk_dsi.c b/drivers/gpu/drm/mediatek/mtk_dsi.c index b3676426aeb5..b02373b04848 100644 --- a/drivers/gpu/drm/mediatek/mtk_dsi.c +++ b/drivers/gpu/drm/mediatek/mtk_dsi.c @@ -136,12 +136,6 @@ #define DATA_0 (0xff << 16) #define DATA_1 (0xff << 24) -#define T_LPX 5 -#define T_HS_PREP 6 -#define T_HS_TRAIL 8 -#define T_HS_EXIT 7 -#define T_HS_ZERO 10 - #define NS_TO_CYCLE(n, c) ((n) / (c) + (((n) % (c)) ? 1 : 0)) #define MTK_DSI_HOST_IS_READ(type) \ @@ -150,6 +144,25 @@ (type == MIPI_DSI_GENERIC_READ_REQUEST_2_PARAM) || \ (type == MIPI_DSI_DCS_READ)) +struct mtk_phy_timing { + u32 lpx; + u32 da_hs_prepare; + u32 da_hs_zero; + u32 da_hs_trail; + + u32 ta_go; + u32 ta_sure; + u32 ta_get; + u32 da_hs_exit; + + u32 clk_hs_zero; + u32 clk_hs_trail; + + u32 clk_hs_prepare; + u32 clk_hs_post; + u32 clk_hs_exit; +}; + struct phy; struct mtk_dsi_driver_data { @@ -180,6 +193,7 @@ struct mtk_dsi { enum mipi_dsi_pixel_format format; unsigned int lanes; struct videomode vm; + struct mtk_phy_timing phy_timing; int refcount; bool enabled; u32 irq_data; @@ -213,17 +227,36 @@ static void mtk_dsi_phy_timconfig(struct mtk_dsi *dsi) { u32 timcon0, timcon1, timcon2, timcon3; u32 ui, cycle_time; + struct mtk_phy_timing *timing = &dsi->phy_timing; + + ui = DIV_ROUND_UP(1000000000, dsi->data_rate); + cycle_time = div_u64(8000000000ULL, dsi->data_rate); + + timing->lpx = NS_TO_CYCLE(60, cycle_time); + timing->da_hs_prepare = NS_TO_CYCLE(50 + 5 * ui, cycle_time); + timing->da_hs_zero = NS_TO_CYCLE(110 + 6 * ui, cycle_time); + timing->da_hs_trail = NS_TO_CYCLE(77 + 4 * ui, cycle_time); - ui = 1000 / dsi->data_rate + 0x01; - cycle_time = 8000 / dsi->data_rate + 0x01; + timing->ta_go = 4 * timing->lpx; + timing->ta_sure = 3 * timing->lpx / 2; + timing->ta_get = 5 * timing->lpx; + timing->da_hs_exit = 2 * timing->lpx; - timcon0 = T_LPX | T_HS_PREP << 8 | T_HS_ZERO << 16 | T_HS_TRAIL << 24; - timcon1 = 4 * T_LPX | (3 * T_LPX / 2) << 8 | 5 * T_LPX << 16 | - T_HS_EXIT << 24; - timcon2 = ((NS_TO_CYCLE(0x64, cycle_time) + 0xa) << 24) | - (NS_TO_CYCLE(0x150, cycle_time) << 16); - timcon3 = NS_TO_CYCLE(0x40, cycle_time) | (2 * T_LPX) << 16 | - NS_TO_CYCLE(80 + 52 * ui, cycle_time) << 8; + timing->clk_hs_zero = NS_TO_CYCLE(336, cycle_time); + timing->clk_hs_trail = NS_TO_CYCLE(100, cycle_time) + 10; + + timing->clk_hs_prepare = NS_TO_CYCLE(64, cycle_time); + timing->clk_hs_post = NS_TO_CYCLE(80 + 52 * ui, cycle_time); + timing->clk_hs_exit = 2 * timing->lpx; + + timcon0 = timing->lpx | timing->da_hs_prepare << 8 | + timing->da_hs_zero << 16 | timing->da_hs_trail << 24; + timcon1 = timing->ta_go | timing->ta_sure << 8 | + timing->ta_get << 16 | timing->da_hs_exit << 24; + timcon2 = 1 << 8 | timing->clk_hs_zero << 16 | + timing->clk_hs_trail << 24; + timcon3 = timing->clk_hs_prepare | timing->clk_hs_post << 8 | + timing->clk_hs_exit << 16; writel(timcon0, dsi->regs + DSI_PHY_TIMECON0); writel(timcon1, dsi->regs + DSI_PHY_TIMECON1); @@ -410,7 +443,8 @@ static void mtk_dsi_config_vdo_timing(struct mtk_dsi *dsi) u32 horizontal_sync_active_byte; u32 horizontal_backporch_byte; u32 horizontal_frontporch_byte; - u32 dsi_tmp_buf_bpp; + u32 dsi_tmp_buf_bpp, data_phy_cycles; + struct mtk_phy_timing *timing = &dsi->phy_timing; struct videomode *vm = &dsi->vm; @@ -437,7 +471,34 @@ static void mtk_dsi_config_vdo_timing(struct mtk_dsi *dsi) horizontal_backporch_byte = ((vm->hback_porch + vm->hsync_len) * dsi_tmp_buf_bpp - 10); - horizontal_frontporch_byte = (vm->hfront_porch * dsi_tmp_buf_bpp - 12); + data_phy_cycles = timing->lpx + timing->da_hs_prepare + + timing->da_hs_zero + timing->da_hs_exit + 2; + + if (dsi->mode_flags & MIPI_DSI_MODE_VIDEO_BURST) { + if (vm->hfront_porch * dsi_tmp_buf_bpp > + data_phy_cycles * dsi->lanes + 18) { + horizontal_frontporch_byte = vm->hfront_porch * + dsi_tmp_buf_bpp - + data_phy_cycles * + dsi->lanes - 18; + } else { + DRM_WARN("HFP less than d-phy, FPS will under 60Hz\n"); + horizontal_frontporch_byte = vm->hfront_porch * + dsi_tmp_buf_bpp; + } + } else { + if (vm->hfront_porch * dsi_tmp_buf_bpp > + data_phy_cycles * dsi->lanes + 12) { + horizontal_frontporch_byte = vm->hfront_porch * + dsi_tmp_buf_bpp - + data_phy_cycles * + dsi->lanes - 12; + } else { + DRM_WARN("HFP less than d-phy, FPS will under 60Hz\n"); + horizontal_frontporch_byte = vm->hfront_porch * + dsi_tmp_buf_bpp; + } + } writel(horizontal_sync_active_byte, dsi->regs + DSI_HSA_WC); writel(horizontal_backporch_byte, dsi->regs + DSI_HBP_WC); @@ -537,8 +598,7 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi) { struct device *dev = dsi->host.dev; int ret; - u64 pixel_clock, total_bits; - u32 htotal, htotal_bits, bit_per_pixel, overhead_cycles, overhead_bits; + u32 bit_per_pixel; if (++dsi->refcount != 1) return 0; @@ -557,24 +617,8 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi) break; } - /** - * htotal_time = htotal * byte_per_pixel / num_lanes - * overhead_time = lpx + hs_prepare + hs_zero + hs_trail + hs_exit - * mipi_ratio = (htotal_time + overhead_time) / htotal_time - * data_rate = pixel_clock * bit_per_pixel * mipi_ratio / num_lanes; - */ - pixel_clock = dsi->vm.pixelclock; - htotal = dsi->vm.hactive + dsi->vm.hback_porch + dsi->vm.hfront_porch + - dsi->vm.hsync_len; - htotal_bits = htotal * bit_per_pixel; - - overhead_cycles = T_LPX + T_HS_PREP + T_HS_ZERO + T_HS_TRAIL + - T_HS_EXIT; - overhead_bits = overhead_cycles * dsi->lanes * 8; - total_bits = htotal_bits + overhead_bits; - - dsi->data_rate = DIV_ROUND_UP_ULL(pixel_clock * total_bits, - htotal * dsi->lanes); + dsi->data_rate = DIV_ROUND_UP_ULL(dsi->vm.pixelclock * bit_per_pixel, + dsi->lanes); ret = clk_set_rate(dsi->hs_clk, dsi->data_rate); if (ret < 0) { -- 2.21.0 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel