Add support for the LCD panels that must be driven with the Sharp-specific signals SPL, CLS, REV, PS. An example of such panel is the LS020B1DD01D supported by the panel-simple DRM panel driver. Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx> --- drivers/gpu/drm/ingenic/ingenic-drm.c | 64 +++++++++++++++++---------- 1 file changed, 41 insertions(+), 23 deletions(-) diff --git a/drivers/gpu/drm/ingenic/ingenic-drm.c b/drivers/gpu/drm/ingenic/ingenic-drm.c index 02c4788ef1c7..da966f3dc1f7 100644 --- a/drivers/gpu/drm/ingenic/ingenic-drm.c +++ b/drivers/gpu/drm/ingenic/ingenic-drm.c @@ -166,6 +166,8 @@ struct ingenic_drm { struct ingenic_dma_hwdesc *dma_hwdesc; dma_addr_t dma_hwdesc_phys; + + bool panel_is_sharp; }; static const u32 ingenic_drm_primary_formats[] = { @@ -283,6 +285,13 @@ static void ingenic_drm_crtc_update_timings(struct ingenic_drm *priv, regmap_write(priv->map, JZ_REG_LCD_DAV, vds << JZ_LCD_DAV_VDS_OFFSET | vde << JZ_LCD_DAV_VDE_OFFSET); + + if (priv->panel_is_sharp) { + regmap_write(priv->map, JZ_REG_LCD_PS, hde << 16 | (hde + 1)); + regmap_write(priv->map, JZ_REG_LCD_CLS, hde << 16 | (hde + 1)); + regmap_write(priv->map, JZ_REG_LCD_SPL, hpe << 16 | (hpe + 1)); + regmap_write(priv->map, JZ_REG_LCD_REV, mode->htotal << 16); + } } static void ingenic_drm_crtc_update_ctrl(struct ingenic_drm *priv, @@ -378,11 +387,18 @@ static void ingenic_drm_encoder_atomic_mode_set(struct drm_encoder *encoder, { struct ingenic_drm *priv = drm_encoder_get_priv(encoder); struct drm_display_mode *mode = &crtc_state->adjusted_mode; - struct drm_display_info *info = &conn_state->connector->display_info; - unsigned int cfg = JZ_LCD_CFG_PS_DISABLE - | JZ_LCD_CFG_CLS_DISABLE - | JZ_LCD_CFG_SPL_DISABLE - | JZ_LCD_CFG_REV_DISABLE; + struct drm_connector *conn = conn_state->connector; + struct drm_display_info *info = &conn->display_info; + unsigned int cfg; + + priv->panel_is_sharp = info->bus_flags & DRM_BUS_FLAG_SHARP_SIGNALS; + + if (priv->panel_is_sharp) { + cfg = JZ_LCD_CFG_MODE_SPECIAL_TFT_1 | JZ_LCD_CFG_REV_POLARITY; + } else { + cfg = JZ_LCD_CFG_PS_DISABLE | JZ_LCD_CFG_CLS_DISABLE + | JZ_LCD_CFG_SPL_DISABLE | JZ_LCD_CFG_REV_DISABLE; + } if (mode->flags & DRM_MODE_FLAG_NHSYNC) cfg |= JZ_LCD_CFG_HSYNC_ACTIVE_LOW; @@ -393,24 +409,26 @@ static void ingenic_drm_encoder_atomic_mode_set(struct drm_encoder *encoder, if (info->bus_flags & DRM_BUS_FLAG_PIXDATA_NEGEDGE) cfg |= JZ_LCD_CFG_PCLK_FALLING_EDGE; - if (conn_state->connector->connector_type == DRM_MODE_CONNECTOR_TV) { - if (mode->flags & DRM_MODE_FLAG_INTERLACE) - cfg |= JZ_LCD_CFG_MODE_TV_OUT_I; - else - cfg |= JZ_LCD_CFG_MODE_TV_OUT_P; - } else { - switch (*info->bus_formats) { - case MEDIA_BUS_FMT_RGB565_1X16: - cfg |= JZ_LCD_CFG_MODE_GENERIC_16BIT; - break; - case MEDIA_BUS_FMT_RGB666_1X18: - cfg |= JZ_LCD_CFG_MODE_GENERIC_18BIT; - break; - case MEDIA_BUS_FMT_RGB888_1X24: - cfg |= JZ_LCD_CFG_MODE_GENERIC_24BIT; - break; - default: - break; + if (!priv->panel_is_sharp) { + if (conn->connector_type == DRM_MODE_CONNECTOR_TV) { + if (mode->flags & DRM_MODE_FLAG_INTERLACE) + cfg |= JZ_LCD_CFG_MODE_TV_OUT_I; + else + cfg |= JZ_LCD_CFG_MODE_TV_OUT_P; + } else { + switch (*info->bus_formats) { + case MEDIA_BUS_FMT_RGB565_1X16: + cfg |= JZ_LCD_CFG_MODE_GENERIC_16BIT; + break; + case MEDIA_BUS_FMT_RGB666_1X18: + cfg |= JZ_LCD_CFG_MODE_GENERIC_18BIT; + break; + case MEDIA_BUS_FMT_RGB888_1X24: + cfg |= JZ_LCD_CFG_MODE_GENERIC_24BIT; + break; + default: + break; + } } } -- 2.21.0.593.g511ec345e18 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel