Re: [PATCH 0/2] Add DRM panel driver for Ilitek ILI9341 based panels in parallel RGB mode

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Josef.

On Tue, Feb 19, 2019 at 02:20:59PM +0100, Josef Lusticky wrote:
> These patches add panel driver for ili9341-based panels in parallel RGB mode.
> The driver was developed for DispleyTech DT024CTFT LCD panel [1] which features ILI9341 chip [2].
> The driver was tested on the Allwinner A13 (sun5i) platform.
> 
> The driver supports 240x320 pixel resolution with 18-bit RGB (6 wires per color)
> and SPI control bus with Data/Command GPIO pin.
> 
> The Data/Command GPIO is optional, however at the moment the driver requires it:
> The display itself is capable of 9-bit SPI without the Data/Command GPIO.
> Support for such configuration can be added later to the driver.
> 
> Optional HW reset gpio can be specified, otherwise SW reset command is used
> during the initialization.
> 
> The ILI9341 displays have two command sets:
> Level 1 conforms to MIPI specs
> Level 2 is outside the MIPI specs - custom defines are used in the driver
> 
> The ILI9341 supports various RGB modes (e.g. NVSYNC, DE_LOW, clock freq, etc.),
> however values that are presented in the ILI9341 datasheet [2] are used
> by the driver in struct drm_display_mode.
> 
> 
> General note on ILI9341-based displays:
> The ILI9341 chip can be used in parallel RGB with SPI control
> or in SPI only mode where the image data itself is also transferred via SPI.
> This driver supports parallel RGB displays - it works with displays wired with 18-bit RGB input,
> it does not support SPI data mode (i.e. Multi-inno mi0283qt or Adafruit yx240qv29 are not supported by this driver).
> The SPI data mode is naturally much slower than the parallel RGB mode.
> 
> General note on DisplayTech DT024CTFT panel:
> The panel supports different configuation options (18/16/6-bit RGB or 9/8-bit SPI) depending on the IM[0:3] wiring.
> To keep this patch small for reveiw, at the moment only 18-bit RGB mode and 8-bit SPI with Data/Command GPIO
> is supported by this driver.
> 
> 
> I kindly ask you for a patch review.
Did you get around to send a v2 of this patchset?

	Sam
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel




[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux