https://bugs.freedesktop.org/show_bug.cgi?id=48880 --- Comment #18 from Alex Deucher <agd5f@xxxxxxxxx> 2012-04-19 07:01:10 PDT --- (In reply to comment #15) > > Err, Alex, i think that it is the display engine, for a particular version and > process, that has issues with certain divider combinations which should > theoretically produce the same pixel clock, not the monitor. I'm not so sure about that. If I use the same divider combination on my monitors, it works fine (both TMDS and analog). It even works fine for Tvrtko over TMDS. It's possible the that due to a cable problem or a bad solder inside that the pixel clock that eventually gets to the screen is in some cases is too low and boosting the pixel clock slightly compensates for that. (In reply to comment #16) > > I don't take that as granted because monitor was reporting 175.9MHz in the > broken case. You haven't said anything about that observation? Do you believe > monitor is wrong there? Even though it correctly reports with other modes? > I don't know why the monitor is reporting that or how the monitor calculates the clock it's getting. It could be something funky with the VGA cable you are using or a loose connection on the VGA chain somewhere. The exact same divider combination works fine on DVI and on other monitors. > > I'd be leery of changing the pll flags without a lot of thorough testing since > > these change may break certain modes on other monitors. Did you try > > RADEON_PLL_USE_FRAC_FB_DIV? It should help the driver get closer to the actual > > pixel clock by allowing a finer grained fb divider, but once again, some > > monitors are picky about certain divider combinations. I'd be more inclined to > > add this flag than the MINM_OVER_MAXP flag however. > > I haven't tried RADEON_PLL_USE_FRAC_FB_DIV yet, but will now. What are the > downsides of that one? I suppose there must be some since it is not enabled by > default... Once again, some monitors don't like the clock produced. It took years of fine tuning to get a pll algo that produces good results on a wide range of monitors. these options may fix this mode on your monitor, but they may also break a bunch of modes on other monitors. -- Configure bugmail: https://bugs.freedesktop.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug. _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel
