Hi all.
Please see mail below - is it OK to extend drm_bus_flags to
represent "SHARP signals"?
Paul (and I) could not find any better way to let the panel tell the
display driver that it requires the special SHARP signals.
This has been pending almost a month now and it would only be fair
to either accept the solution or to give Paul guidiance how to move
forward.
There is a display driver that awaits the resilutions of this issue.
Sam
On Fri, Apr 26, 2019 at 01:18:53AM +0200, Paul Cercueil wrote:
> Add the DRM_BUS_FLAG_SHARP_SIGNALS to the drm_bus_flags enum.
>
> This flags can be used when the display must be driven with the
> Sharp-specific signals SPL, CLS, REV, PS.
>
> Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>
> ---
>
> Notes:
> v3: New patch
>
> include/drm/drm_connector.h | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/include/drm/drm_connector.h b/include/drm/drm_connector.h
> index 02a131202add..ac7d58fd1e03 100644
> --- a/include/drm/drm_connector.h
> +++ b/include/drm/drm_connector.h
> @@ -323,6 +323,8 @@ enum drm_panel_orientation {
> * edge of the pixel clock
> * @DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE: Sync signals are sampled on the falling
> * edge of the pixel clock
> + * @DRM_BUS_FLAG_SHARP_SIGNALS: Set if the Sharp-specific signals
> + * (SPL, CLS, PS, REV) must be used
> */
> enum drm_bus_flags {
> DRM_BUS_FLAG_DE_LOW = BIT(0),
> @@ -341,6 +343,7 @@ enum drm_bus_flags {
> DRM_BUS_FLAG_SYNC_DRIVE_NEGEDGE = DRM_BUS_FLAG_SYNC_NEGEDGE,
> DRM_BUS_FLAG_SYNC_SAMPLE_POSEDGE = DRM_BUS_FLAG_SYNC_NEGEDGE,
> DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE = DRM_BUS_FLAG_SYNC_POSEDGE,
> + DRM_BUS_FLAG_SHARP_SIGNALS = BIT(8),
> };
>
> /**
> --
> 2.21.0.593.g511ec345e18
>
> _______________________________________________
> dri-devel mailing list
> dri-devel@xxxxxxxxxxxxxxxxxxxxx
> https://lists.freedesktop.org/mailman/listinfo/dri-devel
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
