On Thu, May 16, 2019 at 8:48 AM Torsten Duwe <duwe@xxxxxx> wrote: > > On Wed, May 15, 2019 at 08:08:57AM -0700, Vasily Khoruzhick wrote: > > On Wed, May 15, 2019 at 12:32 AM Torsten Duwe <duwe@xxxxxx> wrote: > > > > > > It does comply with the bindings. The ports are all optional. > > > As far as DT is concerned, the signal path ends here. This is also the > > > final component _required_ to get the Linux kernel DRI up and running. > > > > Ugh, then bindings should be fixed. It's not optional. It may work if > > bootloader enables power for you, but it won't if you disable display > > driver in u-boot. > > I double-checked. On the Teres-I, mentioning the panel _is_ optional. It's not. See power on sequence in https://www.olimex.com/Products/DIY-Laptop/SPARE-PARTS/TERES-015-LCD11-6/resources/N116BGE-EA2.pdf Driver can talk to the panel over AUX channel only after t1+t3, t1 is up to 10ms, t3 is up to 200ms. It works with older version of driver that keeps panel always on because it takes a while between driver probe and pipeline start. It'll likely break with newer version of driver that turns on panel only when bridge is active. You'll see AUX timeouts - it won't be able to probe EDID in some cases. Problem can be intermittent and device dependent. All in all - you don't need panel timings since there's EDID but you still need panel delays. Anyway, it's up to you and maintainers. > PD23 powers down panel and backlight as much as possible, see > 24bd5d2cb93bc arm64: dts: allwinner: a64: teres-i: enable backlight > (currently only in Maxime's repo) and the Teres-I schematics... > > And the driver in your repo neatly guards all accesses with > "if (anx6345->panel)" -- good! > But I found the Vdds are required, so I added them as such. > > > I guess you're testing it with older version of anx6345. Newer version > > that supports power management [1] needs startup delay for panel. > > Another issue that you're seeing is that backlight is not disabled on > > DPMS events. All in all, you need to describe panel in dts. > > > > [1] https://github.com/anarsoul/linux-2.6/commit/2fbf9c242419c8bda698e8331a02d4312143ae2c > > > > Should I also have added a Tested-by: ? ;-) > > > > I don't have Teres, so I haven't tested these. > > *I* have one, and this works. I'll retest with your newer driver, > just in case. Nonetheless, the changes in this series should be fine. > Sending out v2 in a moment... > > Torsten > _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
