On Thu, May 02, 2019 at 11:19:50AM +0100, Daniel Thompson wrote: > On 24/04/2019 10:25, Brian Masney wrote: > > Add fwnode support to the lm3630a driver and optionally allow > > configuring the label, default brightness level, and maximum brightness > > level. The two outputs can be controlled by bank A and B independently > > or bank A can control both outputs. > > > > If the platform data was not configured, then the driver defaults to > > enabling both banks. This patch changes the default value to disable > > both banks before parsing the firmware node so that just a single bank > > can be enabled if desired. There are no in-tree users of this driver. > > In that case given I'd certainly entertain patches that move the config > structures out of include/linux/platform_data and say the driver requires a > proper entry in the hardware description! Not a requirement though. OK, I'll submit patches for that after this series is merged. Brian _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
