Currently if the GMU resume function fails all we try to do is clear the
BOOT_SLUMBER oob which usually times out and ends up in a cycle of death.
If the resume function fails at any point remove any RPMh votes that might
have been added and try to shut down the GMU hardware cleanly.
Signed-off-by: Jordan Crouse <jcrouse@xxxxxxxxxxxxxx>
---
drivers/gpu/drm/msm/adreno/a6xx_gmu.c | 82 +++++++++++++++++++-----------
drivers/gpu/drm/msm/adreno/a6xx_gpu.c | 20 ++------
drivers/gpu/drm/msm/adreno/adreno_device.c | 1 +
3 files changed, 58 insertions(+), 45 deletions(-)
diff --git a/drivers/gpu/drm/msm/adreno/a6xx_gmu.c b/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
index e16d55d..2e89ca3 100644
--- a/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
+++ b/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
@@ -638,20 +638,6 @@ static int a6xx_gmu_fw_start(struct a6xx_gmu *gmu, unsigned int state)
A6XX_GMU_AO_HOST_INTERRUPT_STATUS_HOST_AHB_BUS_ERROR | \
A6XX_GMU_AO_HOST_INTERRUPT_STATUS_FENCE_ERR)
-static void a6xx_gmu_irq_enable(struct a6xx_gmu *gmu)
-{
- gmu_write(gmu, REG_A6XX_GMU_AO_HOST_INTERRUPT_CLR, ~0);
- gmu_write(gmu, REG_A6XX_GMU_GMU2HOST_INTR_CLR, ~0);
-
- gmu_write(gmu, REG_A6XX_GMU_AO_HOST_INTERRUPT_MASK,
- ~A6XX_GMU_IRQ_MASK);
- gmu_write(gmu, REG_A6XX_GMU_GMU2HOST_INTR_MASK,
- ~A6XX_HFI_IRQ_MASK);
-
- enable_irq(gmu->gmu_irq);
- enable_irq(gmu->hfi_irq);
-}
-
static void a6xx_gmu_irq_disable(struct a6xx_gmu *gmu)
{
disable_irq(gmu->gmu_irq);
@@ -661,11 +647,24 @@ static void a6xx_gmu_irq_disable(struct a6xx_gmu *gmu)
gmu_write(gmu, REG_A6XX_GMU_GMU2HOST_INTR_MASK, ~0);
}
-/* Force the GMU off in case it isn't responsive */
-static void a6xx_gmu_force_off(struct a6xx_gmu *gmu)
+static void a6xx_gmu_rpmh_off(struct a6xx_gmu *gmu)
{
u32 val;
+ /* Make sure there are no outstanding RPMh votes */
+ gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS0_DRV0_STATUS, val,
+ (val & 1), 100, 10000);
+ gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS1_DRV0_STATUS, val,
+ (val & 1), 100, 10000);
+ gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS2_DRV0_STATUS, val,
+ (val & 1), 100, 10000);
+ gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS3_DRV0_STATUS, val,
+ (val & 1), 100, 1000);
+}
+
+/* Force the GMU off in case it isn't responsive */
+static void a6xx_gmu_force_off(struct a6xx_gmu *gmu)
+{
/* Flush all the queues */
a6xx_hfi_stop(gmu);
@@ -676,14 +675,7 @@ static void a6xx_gmu_force_off(struct a6xx_gmu *gmu)
a6xx_sptprac_disable(gmu);
/* Make sure there are no outstanding RPMh votes */
- gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS0_DRV0_STATUS, val,
- (val & 1), 100, 10000);
- gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS1_DRV0_STATUS, val,
- (val & 1), 100, 10000);
- gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS2_DRV0_STATUS, val,
- (val & 1), 100, 10000);
- gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS3_DRV0_STATUS, val,
- (val & 1), 100, 1000);
+ a6xx_gmu_rpmh_off(gmu);
}
int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
@@ -702,10 +694,15 @@ int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
/* Use a known rate to bring up the GMU */
clk_set_rate(gmu->core_clk, 200000000);
ret = clk_bulk_prepare_enable(gmu->nr_clocks, gmu->clocks);
- if (ret)
- goto out;
+ if (ret) {
+ pm_runtime_put(gmu->dev);
+ return ret;
+ }
- a6xx_gmu_irq_enable(gmu);
+ /* Enable the GMU interrupt */
+ gmu_write(gmu, REG_A6XX_GMU_AO_HOST_INTERRUPT_CLR, ~0);
+ gmu_write(gmu, REG_A6XX_GMU_AO_HOST_INTERRUPT_MASK, ~A6XX_GMU_IRQ_MASK);
+ enable_irq(gmu->gmu_irq);
/* Check to see if we are doing a cold or warm boot */
status = gmu_read(gmu, REG_A6XX_GMU_GENERAL_7) == 1 ?
@@ -716,6 +713,16 @@ int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
goto out;
ret = a6xx_hfi_start(gmu, status);
+ if (ret)
+ goto out;
+
+ /*
+ * Turn on the GMU firmware fault interrupt after we know the boot
+ * sequence is successful
+ */
+ gmu_write(gmu, REG_A6XX_GMU_GMU2HOST_INTR_CLR, ~0);
+ gmu_write(gmu, REG_A6XX_GMU_GMU2HOST_INTR_MASK, ~A6XX_HFI_IRQ_MASK);
+ enable_irq(gmu->hfi_irq);
/* Set the GPU to the highest power frequency */
__a6xx_gmu_set_freq(gmu, gmu->nr_gpu_freqs - 1);
@@ -729,9 +736,12 @@ int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
pm_runtime_get(gmu->gxpd);
out:
- /* Make sure to turn off the boot OOB request on error */
- if (ret)
- a6xx_gmu_clear_oob(gmu, GMU_OOB_BOOT_SLUMBER);
+ /* On failure, shut down the GMU to leave it in a good state */
+ if (ret) {
+ disable_irq(gmu->gmu_irq);
+ a6xx_rpmh_stop(gmu);
+ pm_runtime_put(gmu->dev);
+ }
return ret;
}
@@ -754,6 +764,9 @@ bool a6xx_gmu_isidle(struct a6xx_gmu *gmu)
/* Gracefully try to shut down the GMU and by extension the GPU */
static void a6xx_gmu_shutdown(struct a6xx_gmu *gmu)
{
+ struct a6xx_gpu *a6xx_gpu = container_of(gmu, struct a6xx_gpu, gmu);
+ struct adreno_gpu *adreno_gpu = &a6xx_gpu->base;
+ struct msm_gpu *gpu = &adreno_gpu->base;
u32 val;
/*
@@ -771,6 +784,12 @@ static void a6xx_gmu_shutdown(struct a6xx_gmu *gmu)
return;
}
+ /* Clear the VBIF pipe before shutting down */
+ gpu_write(gpu, REG_A6XX_VBIF_XIN_HALT_CTRL0, 0xf);
+ spin_until((gpu_read(gpu, REG_A6XX_VBIF_XIN_HALT_CTRL1) & 0xf)
+ == 0xf);
+ gpu_write(gpu, REG_A6XX_VBIF_XIN_HALT_CTRL0, 0);
+
/* tell the GMU we want to slumber */
a6xx_gmu_notify_slumber(gmu);
@@ -808,6 +827,9 @@ int a6xx_gmu_stop(struct a6xx_gpu *a6xx_gpu)
{
struct a6xx_gmu *gmu = &a6xx_gpu->gmu;
+ if (!pm_runtime_active(gmu->dev))
+ return 0;
+
/*
* Force the GMU off if we detected a hang, otherwise try to shut it
* down gracefully
diff --git a/drivers/gpu/drm/msm/adreno/a6xx_gpu.c b/drivers/gpu/drm/msm/adreno/a6xx_gpu.c
index f76d8cd..576559a 100644
--- a/drivers/gpu/drm/msm/adreno/a6xx_gpu.c
+++ b/drivers/gpu/drm/msm/adreno/a6xx_gpu.c
@@ -678,13 +678,15 @@ static int a6xx_pm_resume(struct msm_gpu *gpu)
struct a6xx_gpu *a6xx_gpu = to_a6xx_gpu(adreno_gpu);
int ret;
- ret = a6xx_gmu_resume(a6xx_gpu);
-
gpu->needs_hw_init = true;
+ ret = a6xx_gmu_resume(a6xx_gpu);
+ if (ret)
+ return ret;
+
msm_gpu_resume_devfreq(gpu);
- return ret;
+ return 0;
}
static int a6xx_pm_suspend(struct msm_gpu *gpu)
@@ -694,18 +696,6 @@ static int a6xx_pm_suspend(struct msm_gpu *gpu)
devfreq_suspend_device(gpu->devfreq.devfreq);
- /*
- * Make sure the GMU is idle before continuing (because some transitions
- * may use VBIF
- */
- a6xx_gmu_wait_for_idle(&a6xx_gpu->gmu);
-
- /* Clear the VBIF pipe before shutting down */
- /* FIXME: This accesses the GPU - do we need to make sure it is on? */
- gpu_write(gpu, REG_A6XX_VBIF_XIN_HALT_CTRL0, 0xf);
- spin_until((gpu_read(gpu, REG_A6XX_VBIF_XIN_HALT_CTRL1) & 0xf) == 0xf);
- gpu_write(gpu, REG_A6XX_VBIF_XIN_HALT_CTRL0, 0);
-
return a6xx_gmu_stop(a6xx_gpu);
}
diff --git a/drivers/gpu/drm/msm/adreno/adreno_device.c b/drivers/gpu/drm/msm/adreno/adreno_device.c
index 714ed65..0d87db7 100644
--- a/drivers/gpu/drm/msm/adreno/adreno_device.c
+++ b/drivers/gpu/drm/msm/adreno/adreno_device.c
@@ -229,6 +229,7 @@ struct msm_gpu *adreno_load_gpu(struct drm_device *dev)
ret = pm_runtime_get_sync(&pdev->dev);
if (ret < 0) {
+ pm_runtime_put_sync(&pdev->dev);
DRM_DEV_ERROR(dev->dev, "Couldn't power up the GPU: %d\n", ret);
return NULL;
}
--
2.7.4
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
