Add support for SCDC Setup for TMDS Clock > 3.4GHz and enable TMDS Scrambling when supported or mandatory. This patch also adds an helper to setup the control bit to support the high TMDS Bit Period/TMDS Clock-Period Ratio as required with TMDS Clock > 3.4GHz for HDMI2.0 3840x2160@60/50 modes. These changes were based on work done by Huicong Xu <xhc@xxxxxxxxxxxxxx> and Nickey Yang <nickey.yang@xxxxxxxxxxxxxx> to support HDMI2.0 modes on the Rockchip 4.4 BSP kernel at [1] [1] https://github.com/rockchip-linux/kernel/tree/release-4.4 Cc: Nickey Yang <nickey.yang@xxxxxxxxxxxxxx> Cc: Huicong Xu <xhc@xxxxxxxxxxxxxx> Signed-off-by: Neil Armstrong <narmstrong@xxxxxxxxxxxx> Tested-by: Heiko Stuebner <heiko@xxxxxxxxx> Reviewed-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx> --- drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 85 ++++++++++++++++++++++++++++++- drivers/gpu/drm/bridge/synopsys/dw-hdmi.h | 1 + include/drm/bridge/dw_hdmi.h | 1 + 3 files changed, 85 insertions(+), 2 deletions(-) diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c index 7aae726..6d5a2e9 100644 --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c @@ -27,6 +27,7 @@ #include <drm/drm_atomic_helper.h> #include <drm/drm_edid.h> #include <drm/drm_encoder_slave.h> +#include <drm/drm_scdc_helper.h> #include <drm/drm_probe_helper.h> #include <drm/bridge/dw_hdmi.h> @@ -43,6 +44,11 @@ #define HDMI_EDID_LEN 512 +/* DW-HDMI Controller >= 0x200a are at least compliant with SCDC version 1 */ +#define SCDC_MIN_SOURCE_VERSION 0x1 + +#define HDMI14_MAX_TMDSCLK 340000000 + enum hdmi_datamap { RGB444_8B = 0x01, RGB444_10B = 0x03, @@ -1015,6 +1021,33 @@ void dw_hdmi_phy_i2c_write(struct dw_hdmi *hdmi, unsigned short data, } EXPORT_SYMBOL_GPL(dw_hdmi_phy_i2c_write); +/* + * HDMI2.0 Specifies the following procedure for High TMDS Bit Rates: + * - The Source shall suspend transmission of the TMDS clock and data + * - The Source shall write to the TMDS_Bit_Clock_Ratio bit to change it + * from a 0 to a 1 or from a 1 to a 0 + * - The Source shall allow a minimum of 1 ms and a maximum of 100 ms from + * the time the TMDS_Bit_Clock_Ratio bit is written until resuming + * transmission of TMDS clock and data + * + * To respect the 100ms maximum delay, the dw_hdmi_set_high_tmds_clock_ratio() + * helper should called right before enabling the TMDS Clock and Data in + * the PHY configuration callback. + */ +void dw_hdmi_set_high_tmds_clock_ratio(struct dw_hdmi *hdmi) +{ + unsigned long mtmdsclock = hdmi->hdmi_data.video_mode.mpixelclock; + + /* Control for TMDS Bit Period/TMDS Clock-Period Ratio */ + if (hdmi->connector.display_info.hdmi.scdc.supported) { + if (mtmdsclock > HDMI14_MAX_TMDSCLK) + drm_scdc_set_high_tmds_clock_ratio(hdmi->ddc, 1); + else + drm_scdc_set_high_tmds_clock_ratio(hdmi->ddc, 0); + } +} +EXPORT_SYMBOL_GPL(dw_hdmi_set_high_tmds_clock_ratio); + static void dw_hdmi_phy_enable_powerdown(struct dw_hdmi *hdmi, bool enable) { hdmi_mask_writeb(hdmi, !enable, HDMI_PHY_CONF0, @@ -1216,6 +1249,8 @@ static int hdmi_phy_configure(struct dw_hdmi *hdmi) dw_hdmi_phy_power_off(hdmi); + dw_hdmi_set_high_tmds_clock_ratio(hdmi); + /* Leave low power consumption mode by asserting SVSRET. */ if (phy->has_svsret) dw_hdmi_phy_enable_svsret(hdmi, 1); @@ -1237,6 +1272,10 @@ static int hdmi_phy_configure(struct dw_hdmi *hdmi) return ret; } + /* Wait for resuming transmission of TMDS clock and data */ + if (mpixelclock > HDMI14_MAX_TMDSCLK) + msleep(100); + return dw_hdmi_phy_power_on(hdmi); } @@ -1504,7 +1543,8 @@ static void hdmi_config_vendor_specific_infoframe(struct dw_hdmi *hdmi, static void hdmi_av_composer(struct dw_hdmi *hdmi, const struct drm_display_mode *mode) { - u8 inv_val; + u8 inv_val, bytes; + struct drm_hdmi_info *hdmi_info = &hdmi->connector.display_info.hdmi; struct hdmi_vmode *vmode = &hdmi->hdmi_data.video_mode; int hblank, vblank, h_de_hs, v_de_vs, hsync_len, vsync_len; unsigned int vdisplay; @@ -1514,7 +1554,9 @@ static void hdmi_av_composer(struct dw_hdmi *hdmi, dev_dbg(hdmi->dev, "final pixclk = %d\n", vmode->mpixelclock); /* Set up HDMI_FC_INVIDCONF */ - inv_val = (hdmi->hdmi_data.hdcp_enable ? + inv_val = (hdmi->hdmi_data.hdcp_enable || + vmode->mpixelclock > HDMI14_MAX_TMDSCLK || + hdmi_info->scdc.scrambling.low_rates ? HDMI_FC_INVIDCONF_HDCP_KEEPOUT_ACTIVE : HDMI_FC_INVIDCONF_HDCP_KEEPOUT_INACTIVE); @@ -1563,6 +1605,45 @@ static void hdmi_av_composer(struct dw_hdmi *hdmi, vsync_len /= 2; } + /* Scrambling Control */ + if (hdmi_info->scdc.supported) { + if (vmode->mpixelclock > HDMI14_MAX_TMDSCLK || + hdmi_info->scdc.scrambling.low_rates) { + /* + * HDMI2.0 Specifies the following procedure: + * After the Source Device has determined that + * SCDC_Present is set (=1), the Source Device should + * write the accurate Version of the Source Device + * to the Source Version field in the SCDCS. + * Source Devices compliant shall set the + * Source Version = 1. + */ + drm_scdc_readb(&hdmi->i2c->adap, SCDC_SINK_VERSION, + &bytes); + drm_scdc_writeb(&hdmi->i2c->adap, SCDC_SOURCE_VERSION, + min_t(u8, bytes, SCDC_MIN_SOURCE_VERSION)); + + /* Enabled Scrambling in the Sink */ + drm_scdc_set_scrambling(&hdmi->i2c->adap, 1); + + /* + * To activate the scrambler feature, you must ensure + * that the quasi-static configuration bit + * fc_invidconf.HDCP_keepout is set at configuration + * time, before the required mc_swrstzreq.tmdsswrst_req + * reset request is issued. + */ + hdmi_writeb(hdmi, (u8)~HDMI_MC_SWRSTZ_TMDSSWRST_REQ, + HDMI_MC_SWRSTZ); + hdmi_writeb(hdmi, 1, HDMI_FC_SCRAMBLER_CTRL); + } else { + hdmi_writeb(hdmi, 0, HDMI_FC_SCRAMBLER_CTRL); + hdmi_writeb(hdmi, (u8)~HDMI_MC_SWRSTZ_TMDSSWRST_REQ, + HDMI_MC_SWRSTZ); + drm_scdc_set_scrambling(&hdmi->i2c->adap, 0); + } + } + /* Set up horizontal active pixel width */ hdmi_writeb(hdmi, mode->hdisplay >> 8, HDMI_FC_INHACTV1); hdmi_writeb(hdmi, mode->hdisplay, HDMI_FC_INHACTV0); diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h index 9d90eb9..3f3c616 100644 --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h @@ -255,6 +255,7 @@ #define HDMI_FC_MASK2 0x10DA #define HDMI_FC_POL2 0x10DB #define HDMI_FC_PRCONF 0x10E0 +#define HDMI_FC_SCRAMBLER_CTRL 0x10E1 #define HDMI_FC_GMD_STAT 0x1100 #define HDMI_FC_GMD_EN 0x1101 diff --git a/include/drm/bridge/dw_hdmi.h b/include/drm/bridge/dw_hdmi.h index 9f93895..66e7077 100644 --- a/include/drm/bridge/dw_hdmi.h +++ b/include/drm/bridge/dw_hdmi.h @@ -159,6 +159,7 @@ void dw_hdmi_setup_rx_sense(struct dw_hdmi *hdmi, bool hpd, bool rx_sense); void dw_hdmi_set_sample_rate(struct dw_hdmi *hdmi, unsigned int rate); void dw_hdmi_audio_enable(struct dw_hdmi *hdmi); void dw_hdmi_audio_disable(struct dw_hdmi *hdmi); +void dw_hdmi_set_high_tmds_clock_ratio(struct dw_hdmi *hdmi); /* PHY configuration */ void dw_hdmi_phy_i2c_set_addr(struct dw_hdmi *hdmi, u8 address); -- 2.7.4 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
