When the pipe_config's update_pipe flag is set we may need to update the
panel fitting settings. On GEN9+ this means we need to update the crtc's
scaler settings.
This fixes the following WARN_ON, during i915 loading on an Asrock
B150M Pro4S/D3 board with an i5-6500 CPU / graphics:
[drm:pipe_config_err [i915]] *ERROR* mismatch in pch_pfit.enabled
(expected no, found yes)
pipe state doesn't match!
WARNING: CPU: 3 PID: 305 at drivers/gpu/drm/i915/intel_display.c:12084
With line 12084 being the I915_STATE_WARN call inside the
"if (!intel_pipe_config_compare())" block in verify_crtc_state().
On this board with 2 1920x1080 monitors connected over HDMI the GOP
initializes both monitors at 1920x1080 and despite no scaling being
necessary configures a scaler for one of them.
When booting with fastboot=1 on the initial modeset needs_modeset will
be false while update_pipe is true. Since we were not calling
skl_update_scaler_crtc() in this case we would leave the scaler enabled
causing this error.
Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
drivers/gpu/drm/i915/intel_display.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 62df34d30b1f..df32626e0810 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -10919,7 +10919,7 @@ static int intel_crtc_atomic_check(struct drm_crtc *crtc,
}
if (INTEL_GEN(dev_priv) >= 9) {
- if (mode_changed)
+ if (mode_changed || pipe_config->update_pipe)
ret = skl_update_scaler_crtc(pipe_config);
if (!ret)
--
2.20.1
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
