Re: [Intel-gfx] [PATCH 1/5] drm/dp/mst: Configure no_stop_bit correctly for remote i2c xfers

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Dec 07, 2018 at 12:45:25PM -0800, Dhinakaran Pandiyan wrote:
> On Fri, 2018-09-28 at 21:03 +0300, Ville Syrjala wrote:
> > From: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx>
> > 
> > We aren't supposed to force a stop+start between every i2c msg
> > when performing multi message transfers. This should eg. cause
> > the DDC segment address to be reset back to 0 between writing
> > the segment address and reading the actual EDID extension block.
> > 
> > To quote the E-DDC spec:
> > "... this standard requires that the segment pointer be
> >  reset to 00h when a NO ACK or a STOP condition is received."
> Related question, do you know why the segment and ddc addresses are
> defined as 0x30 and 0x50? The E-DDC spec says they should be at 0x60
> and 0xA0/0xA1.

The spec uses 'slave_address << 1 | r/w'.

-- 
Ville Syrjälä
Intel
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel




[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux