Support for ArcticSand arc1 and arc3 ships is added. Some ranges
and control paths are modified based on the chip id probed via
i2c. Also updates vendor prefix to arctic from arc which was a
mistake in the original driver submission
Signed-off-by: Brian Dodge <bdodge09@xxxxxxxxx>
---
.../bindings/leds/backlight/arcxcnn_bl.txt | 20 ++++++++++----------
1 file changed, 10 insertions(+), 10 deletions(-)
diff --git a/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt b/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
index dcaa239..230abde 100644
--- a/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
+++ b/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
@@ -1,8 +1,8 @@
-Binding for ArcticSand arc family LED drivers
+Binding for ArcticSand arc2c0608 LED driver
Required properties:
-- compatible: "arctic,arc1c0608", "arctic,arc2c0608", "arctic,arc3c0845"
-- reg: slave address
+- compatible: should be "arc,arc2c0608"
+- reg: slave address
Optional properties:
- default-brightness: brightness value on boot, value from: 0-4095
@@ -11,19 +11,19 @@ Optional properties:
- led-sources: List of enabled channels from 0 to 5.
See Documentation/devicetree/bindings/leds/common.txt
-- arctic,led-config-0: setting for register ILED_CONFIG_0
-- arctic,led-config-1: setting for register ILED_CONFIG_1
-- arctic,dim-freq: PWM mode frequence setting (bits [3:0] used)
-- arctic,comp-config: setting for register CONFIG_COMP
-- arctic,filter-config: setting for register FILTER_CONFIG
-- arctic,trim-config: setting for register IMAXTUNE
+- arc,led-config-0: setting for register ILED_CONFIG_0
+- arc,led-config-1: setting for register ILED_CONFIG_1
+- arc,dim-freq: PWM mode frequence setting (bits [3:0] used)
+- arc,comp-config: setting for register CONFIG_COMP
+- arc,filter-config: setting for register FILTER_CONFIG
+- arc,trim-config: setting for register IMAXTUNE
Note: Optional properties not specified will default to values in IC EPROM
Example:
arc2c0608@30 {
- compatible = "arctic,arc2c0608";
+ compatible = "arc,arc2c0608";
reg = <0x30>;
default-brightness = <500>;
label = "lcd-backlight";
--
2.7.4
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
