On Wed, Oct 10, 2018 at 01:41:31PM +0200, Paul Kocialkowski wrote:
> Some panels need an active-low data enable (DE) signal for the RGB
> interface. This requires flipping a bit in the TCON0 polarity register
> when setting up the mode for the RGB interface.
>
> Add a new helper function to match specific bus flags and use it to set
> the polarity inversion bit for the DE signal when required.
>
> Signed-off-by: Paul Kocialkowski <contact@xxxxxxxx>
> ---
> drivers/gpu/drm/sun4i/sun4i_tcon.c | 28 ++++++++++++++++++++++++++--
> drivers/gpu/drm/sun4i/sun4i_tcon.h | 1 +
> 2 files changed, 27 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpu/drm/sun4i/sun4i_tcon.c b/drivers/gpu/drm/sun4i/sun4i_tcon.c
> index 3fb084f802e2..d249a462ec09 100644
> --- a/drivers/gpu/drm/sun4i/sun4i_tcon.c
> +++ b/drivers/gpu/drm/sun4i/sun4i_tcon.c
> @@ -78,6 +78,24 @@ static int sun4i_tcon_get_pixel_depth(const struct drm_encoder *encoder)
> return -EINVAL;
> }
>
> +static bool sun4i_tcon_match_bus_flags(const struct drm_encoder *encoder,
> + u32 bus_flags)
> +{
> + struct drm_connector *connector;
> + struct drm_display_info *info;
> +
> + connector = sun4i_tcon_get_connector(encoder);
> + if (!connector)
> + return false;
> +
> + info = &connector->display_info;
> +
> + if ((info->bus_flags & bus_flags) == bus_flags)
> + return true;
> +
> + return false;
> +}
> +
> static void sun4i_tcon_channel_set_status(struct sun4i_tcon *tcon, int channel,
> bool enabled)
> {
> @@ -415,6 +433,7 @@ static void sun4i_tcon0_mode_set_lvds(struct sun4i_tcon *tcon,
> }
>
> static void sun4i_tcon0_mode_set_rgb(struct sun4i_tcon *tcon,
> + const struct drm_encoder *encoder,
> const struct drm_display_mode *mode)
> {
> unsigned int bp, hsync, vsync;
> @@ -474,8 +493,13 @@ static void sun4i_tcon0_mode_set_rgb(struct sun4i_tcon *tcon,
> if (mode->flags & DRM_MODE_FLAG_PVSYNC)
> val |= SUN4I_TCON0_IO_POL_VSYNC_POSITIVE;
>
> + if (sun4i_tcon_match_bus_flags(encoder, DRM_BUS_FLAG_DE_LOW))
> + val |= SUN4I_TCON0_IO_POL_DE_NEGATIVE;
> +
There's other flags in use in that function, you should also migrate
them (ideally by splitting that new function into a separate patch).
Maxime
--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
