Hi Stefan, On Wednesday, 5 September 2018 21:10:08 EEST Stefan Agner wrote: > On 05.09.2018 00:07, Laurent Pinchart wrote: > > On Wednesday, 5 September 2018 08:21:10 EEST Stefan Agner wrote: > >> Allow to specify the data-enable polarity required by a dumb VGA > >> DAC converting parallel RGB to VGA. > >> > >> Signed-off-by: Stefan Agner <stefan@xxxxxxxx> > >> --- > >> > >> .../devicetree/bindings/display/bridge/dumb-vga-dac.txt | 1 + > >> 1 file changed, 1 insertion(+) > >> > >> diff --git > >> a/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt > >> b/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt index > >> 164cbb15f04c..adbd2ca0af2f 100644 > >> --- a/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt > >> +++ b/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt > >> @@ -18,6 +18,7 @@ graph bindings specified in > >> Documentation/devicetree/bindings/graph.txt. > >> > >> Optional properties: > >> - vdd-supply: Power supply for DAC > >> > >> +- de-active: data-enable pulse is active low/high/ignored > > > > Which value corresponds to low, high and ignored ? > > The wording is taken from > Documentation/devicetree/bindings/display/panel/display-timing.txt. But > I agree, not very useful. > > 0 is low active, 1 is high active, and none is using driver defaults. > > How about: > - de-active: data-enable pulse is 0=active low/1=active high The data enable signal isn't really a pulse. I would word this as - de-active: Polarity of the data enable signal. 0 for active low, 1 for active high, unset for system-specific defaults. > >> Example > >> ------- -- Regards, Laurent Pinchart _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
