The main axi clk is disabled at the end of mxsfb_crtc_mode_set_nofb and
immediately reenabled in mxsfb_enable_controller.
Avoid this by moving the handling of axi clk one level up to
mxsfb_crtc_enable. Do the same for mxsfb_crtc_disable for symmetry.
This shouldn't have any functional effect.
Signed-off-by: Leonard Crestez <leonard.crestez@xxxxxxx>
Reviewed-by: Stefan Agner <stefan@xxxxxxxx>
---
drivers/gpu/drm/mxsfb/mxsfb_crtc.c | 8 ++------
1 file changed, 2 insertions(+), 6 deletions(-)
diff --git a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c
index 0abe77675b76..e4fcbb65b969 100644
--- a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c
+++ b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c
@@ -127,11 +127,10 @@ static void mxsfb_enable_controller(struct mxsfb_drm_private *mxsfb)
u32 reg;
if (mxsfb->clk_disp_axi)
clk_prepare_enable(mxsfb->clk_disp_axi);
clk_prepare_enable(mxsfb->clk);
- mxsfb_enable_axi_clk(mxsfb);
/* If it was disabled, re-enable the mode again */
writel(CTRL_DOTCLK_MODE, mxsfb->base + LCDC_CTRL + REG_SET);
/* Enable the SYNC signals first, then the DMA engine */
@@ -157,12 +156,10 @@ static void mxsfb_disable_controller(struct mxsfb_drm_private *mxsfb)
reg = readl(mxsfb->base + LCDC_VDCTRL4);
reg &= ~VDCTRL4_SYNC_SIGNALS_ON;
writel(reg, mxsfb->base + LCDC_VDCTRL4);
- mxsfb_disable_axi_clk(mxsfb);
-
clk_disable_unprepare(mxsfb->clk);
if (mxsfb->clk_disp_axi)
clk_disable_unprepare(mxsfb->clk_disp_axi);
}
@@ -206,11 +203,10 @@ static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb)
/*
* It seems, you can't re-program the controller if it is still
* running. This may lead to shifted pictures (FIFO issue?), so
* first stop the controller and drain its FIFOs.
*/
- mxsfb_enable_axi_clk(mxsfb);
/* Mandatory eLCDIF reset as per the Reference Manual */
err = mxsfb_reset_block(mxsfb->base);
if (err)
return;
@@ -267,23 +263,23 @@ static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb)
SET_VERT_WAIT_CNT(m->crtc_vtotal - m->crtc_vsync_start),
mxsfb->base + LCDC_VDCTRL3);
writel(SET_DOTCLK_H_VALID_DATA_CNT(m->hdisplay),
mxsfb->base + LCDC_VDCTRL4);
-
- mxsfb_disable_axi_clk(mxsfb);
}
void mxsfb_crtc_enable(struct mxsfb_drm_private *mxsfb)
{
+ mxsfb_enable_axi_clk(mxsfb);
mxsfb_crtc_mode_set_nofb(mxsfb);
mxsfb_enable_controller(mxsfb);
}
void mxsfb_crtc_disable(struct mxsfb_drm_private *mxsfb)
{
mxsfb_disable_controller(mxsfb);
+ mxsfb_disable_axi_clk(mxsfb);
}
void mxsfb_plane_atomic_update(struct mxsfb_drm_private *mxsfb,
struct drm_plane_state *state)
{
--
2.17.1
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
