Properties like data-lanes, clock-noncontinuous and lane-polarities are applicable to DSI and DisplayPort interface also. So update the documentation to mention the same. Signed-off-by: Sandeep Panda <spanda@xxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/media/video-interfaces.txt | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/media/video-interfaces.txt b/Documentation/devicetree/bindings/media/video-interfaces.txt index 852041a..f53d8e4 100644 --- a/Documentation/devicetree/bindings/media/video-interfaces.txt +++ b/Documentation/devicetree/bindings/media/video-interfaces.txt @@ -99,15 +99,16 @@ Optional endpoint properties determines the logical lane number, while the value of an entry indicates physical lane, e.g. for 2-lane MIPI CSI-2 bus we could have "data-lanes = <1 2>;", assuming the clock lane is on hardware lane 0. - This property is valid for serial busses only (e.g. MIPI CSI-2). + This property is valid for serial busses only (e.g. MIPI CSI-2, MIPI DSI, + DisplayPort). - clock-lanes: an array of physical clock lane indexes. Position of an entry determines the logical lane number, while the value of an entry indicates physical lane, e.g. for a MIPI CSI-2 bus we could have "clock-lanes = <0>;", which places the clock lane on hardware lane 0. This property is valid for serial busses only (e.g. MIPI CSI-2). Note that for the MIPI CSI-2 bus this array contains only one entry. -- clock-noncontinuous: a boolean property to allow MIPI CSI-2 non-continuous - clock mode. +- clock-noncontinuous: a boolean property to allow non-continuous clock mode. + This property is valid for serial busses (e.g. MIPI CSI-2, MIPI DSI and DisplayPort). - link-frequencies: Allowed data bus frequencies. For MIPI CSI-2, for instance, this is the actual frequency of the bus, not bits per clock per lane value. An array of 64-bit unsigned integers. @@ -116,7 +117,8 @@ Optional endpoint properties Valid values are 0 (normal) and 1 (inverted). The length of the array should be the combined length of data-lanes and clock-lanes properties. If the lane-polarities property is omitted, the value must be interpreted - as 0 (normal). This property is valid for serial busses only. + as 0 (normal). This property is valid for serial busses only (e.g. MIPI CSI-2, + MIPI DSI, DisplayPort). - strobe: Whether the clock signal is used as clock (0) or strobe (1). Used with CCP2, for instance. -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
