To avoid duplicate logic for the same
Signed-off-by: Satendra Singh Thakur <satendra.t@xxxxxxxxxxx>
Cc: Madhur Verma <madhur.verma@xxxxxxxxxxx>
Cc: Hemanshu Srivastava <hemanshu.s@xxxxxxxxxxx>
---
drivers/gpu/drm/tilcdc/tilcdc_crtc.c | 60 ++++++++++++++++--------------------
1 file changed, 27 insertions(+), 33 deletions(-)
diff --git a/drivers/gpu/drm/tilcdc/tilcdc_crtc.c b/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
index 1b278a2..6becdaf 100644
--- a/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
+++ b/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
@@ -25,6 +25,7 @@
#include <linux/dma-mapping.h>
#include <linux/of_graph.h>
#include <linux/math64.h>
+#include <video/videomode.h>
#include "tilcdc_drv.h"
#include "tilcdc_regs.h"
@@ -284,9 +285,10 @@ static void tilcdc_crtc_set_mode(struct drm_crtc *crtc)
struct drm_device *dev = crtc->dev;
struct tilcdc_drm_private *priv = dev->dev_private;
const struct tilcdc_panel_info *info = tilcdc_crtc->info;
- uint32_t reg, hbp, hfp, hsw, vbp, vfp, vsw;
+ uint32_t reg;
struct drm_display_mode *mode = &crtc->state->adjusted_mode;
struct drm_framebuffer *fb = crtc->primary->state->fb;
+ struct videomode vm;
if (WARN_ON(!info))
return;
@@ -320,15 +322,12 @@ static void tilcdc_crtc_set_mode(struct drm_crtc *crtc)
tilcdc_write(dev, LCDC_DMA_CTRL_REG, reg);
/* Configure timings: */
- hbp = mode->htotal - mode->hsync_end;
- hfp = mode->hsync_start - mode->hdisplay;
- hsw = mode->hsync_end - mode->hsync_start;
- vbp = mode->vtotal - mode->vsync_end;
- vfp = mode->vsync_start - mode->vdisplay;
- vsw = mode->vsync_end - mode->vsync_start;
+ drm_display_mode_to_videomode(mode, &vm);
- DBG("%dx%d, hbp=%u, hfp=%u, hsw=%u, vbp=%u, vfp=%u, vsw=%u",
- mode->hdisplay, mode->vdisplay, hbp, hfp, hsw, vbp, vfp, vsw);
+ DBG("%dx%d, vm.hback_porch=%u, vm.hfront_porch=%u, vm.hsync_len=%u,"
+ " vm.vback_porch=%u, vm.vfront_porch=%u, vm.vsync_len=%u",
+ vm.hactive, vm.vactive, vm.hback_porch, vm.hfront_porch,
+ vm.hsync_len, vm.vback_porch, vm.vfront_porch, vm.vsync_len);
/* Set AC Bias Period and Number of Transitions per Interrupt: */
reg = tilcdc_read(dev, LCDC_RASTER_TIMING_2_REG) & ~0x000fff00;
@@ -336,30 +335,30 @@ static void tilcdc_crtc_set_mode(struct drm_crtc *crtc)
LCDC_AC_BIAS_TRANSITIONS_PER_INT(info->ac_bias_intrpt);
/*
- * subtract one from hfp, hbp, hsw because the hardware uses
- * a value of 0 as 1
+ * subtract one from vm.hfront_porch, vm.hback_porch, vm.hsync_len
+ * because the hardware uses a value of 0 as 1
*/
if (priv->rev == 2) {
/* clear bits we're going to set */
reg &= ~0x78000033;
- reg |= ((hfp-1) & 0x300) >> 8;
- reg |= ((hbp-1) & 0x300) >> 4;
- reg |= ((hsw-1) & 0x3c0) << 21;
+ reg |= ((vm.hfront_porch-1) & 0x300) >> 8;
+ reg |= ((vm.hback_porch-1) & 0x300) >> 4;
+ reg |= ((vm.hsync_len-1) & 0x3c0) << 21;
}
tilcdc_write(dev, LCDC_RASTER_TIMING_2_REG, reg);
reg = (((mode->hdisplay >> 4) - 1) << 4) |
- (((hbp-1) & 0xff) << 24) |
- (((hfp-1) & 0xff) << 16) |
- (((hsw-1) & 0x3f) << 10);
+ (((vm.hback_porch-1) & 0xff) << 24) |
+ (((vm.hfront_porch-1) & 0xff) << 16) |
+ (((vm.hsync_len-1) & 0x3f) << 10);
if (priv->rev == 2)
reg |= (((mode->hdisplay >> 4) - 1) & 0x40) >> 3;
tilcdc_write(dev, LCDC_RASTER_TIMING_0_REG, reg);
reg = ((mode->vdisplay - 1) & 0x3ff) |
- ((vbp & 0xff) << 24) |
- ((vfp & 0xff) << 16) |
- (((vsw-1) & 0x3f) << 10);
+ ((vm.vback_porch & 0xff) << 24) |
+ ((vm.vfront_porch & 0xff) << 16) |
+ (((vm.vsync_len-1) & 0x3f) << 10);
tilcdc_write(dev, LCDC_RASTER_TIMING_1_REG, reg);
/*
@@ -753,7 +752,7 @@ int tilcdc_crtc_mode_valid(struct drm_crtc *crtc, struct drm_display_mode *mode)
{
struct tilcdc_drm_private *priv = crtc->dev->dev_private;
unsigned int bandwidth;
- uint32_t hbp, hfp, hsw, vbp, vfp, vsw;
+ struct videomode vm;
/*
* check to see if the width is within the range that
@@ -773,39 +772,34 @@ int tilcdc_crtc_mode_valid(struct drm_crtc *crtc, struct drm_display_mode *mode)
mode->hdisplay, mode->vdisplay,
drm_mode_vrefresh(mode), mode->clock);
- hbp = mode->htotal - mode->hsync_end;
- hfp = mode->hsync_start - mode->hdisplay;
- hsw = mode->hsync_end - mode->hsync_start;
- vbp = mode->vtotal - mode->vsync_end;
- vfp = mode->vsync_start - mode->vdisplay;
- vsw = mode->vsync_end - mode->vsync_start;
+ drm_display_mode_to_videomode(mode, &vm);
- if ((hbp-1) & ~0x3ff) {
+ if ((vm.hback_porch-1) & ~0x3ff) {
DBG("Pruning mode: Horizontal Back Porch out of range");
return MODE_HBLANK_WIDE;
}
- if ((hfp-1) & ~0x3ff) {
+ if ((vm.hfront_porch-1) & ~0x3ff) {
DBG("Pruning mode: Horizontal Front Porch out of range");
return MODE_HBLANK_WIDE;
}
- if ((hsw-1) & ~0x3ff) {
+ if ((vm.hsync_len-1) & ~0x3ff) {
DBG("Pruning mode: Horizontal Sync Width out of range");
return MODE_HSYNC_WIDE;
}
- if (vbp & ~0xff) {
+ if (vm.vback_porch & ~0xff) {
DBG("Pruning mode: Vertical Back Porch out of range");
return MODE_VBLANK_WIDE;
}
- if (vfp & ~0xff) {
+ if (vm.vfront_porch & ~0xff) {
DBG("Pruning mode: Vertical Front Porch out of range");
return MODE_VBLANK_WIDE;
}
- if ((vsw-1) & ~0x3f) {
+ if ((vm.vsync_len-1) & ~0x3f) {
DBG("Pruning mode: Vertical Sync Width out of range");
return MODE_VSYNC_WIDE;
}
--
2.7.4
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
