From: Dave Airlie <airlied@xxxxxxxxxx> If the bpc is set from the connector is 0, we then use it later to adjust in a special case the HDMI pixel clock, however if the bpc is 0, we end up passing a 0 pixel clock into the code. I'm not sure if this is the correct answer or if we should avoid the HDMI clock adjustment for 0 values. This fixes a divide by 0 on my Llano system with a HDMI monitor and hdmi audio enabled. Signed-off-by: Dave Airlie <airlied@xxxxxxxxxx> --- drivers/gpu/drm/radeon/atombios_crtc.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/drivers/gpu/drm/radeon/atombios_crtc.c b/drivers/gpu/drm/radeon/atombios_crtc.c index 2b97262..260fcdc 100644 --- a/drivers/gpu/drm/radeon/atombios_crtc.c +++ b/drivers/gpu/drm/radeon/atombios_crtc.c @@ -554,7 +554,7 @@ static u32 atombios_adjust_pll(struct drm_crtc *crtc, if (encoder->crtc == crtc) { radeon_encoder = to_radeon_encoder(encoder); connector = radeon_get_connector_for_encoder(encoder); - if (connector) + if (connector && connector->display_info.bpc) bpc = connector->display_info.bpc; encoder_mode = atombios_get_encoder_mode(encoder); if ((radeon_encoder->devices & (ATOM_DEVICE_LCD_SUPPORT | ATOM_DEVICE_DFP_SUPPORT)) || -- 1.7.7.3 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel