On Tue, Apr 17, 2018 at 10:45:07AM +0530, Nautiyal, Ankit K wrote: > > On 4/6/2018 11:14 PM, Ville Syrjälä wrote: > > On Fri, Apr 06, 2018 at 10:55:14PM +0530, Nautiyal, Ankit K wrote: > > > This patch is causing failure of IGT test kms_3d. The kms_3d test > > > expects the no. of 3d modes to be 13. > > > > > > (The test has hard-coded value for expected no. of 3d modes as 13) > > > > > > But due to the addition of "matching aspect_ratio" in drm_mode_equal in > > > this patch, the total no. of > > > > > > modes in the connector modelist is increased by 2, resulting in failure > > > of assertion 'mode_count==13'. > > If kms_3d isn't setting the aspect ratio cap how is it affected by these > > changes? > In drm_mode.c, the drm_mode_connector_list_update() uses drm_mode_equal, > to remove duplicate modes in connector_modes from the > connector->probe_modes. > Earlier, it wasn't matching for aspect-ratio and was discarding two of the > modes with aspect ratio, > as duplicates of other modes in the list. > > Later, when we are pruning the modes in drm_mode_get_connector, the logic > there assumes, > that the modes are in a sorted order so that we just match with the last > valid mode for uniqueness. > This isn't the case with the spoofed edid in kms_3d. > Earlier, I was thinking if we should change the no. of expected modes in > kms_3d, > but that's not correct approach. > > So finally, The pruning logic needs to be changed, to do away with any > assumption and check > all the modes in the list for duplicates. This however will take more time > to remove duplicates. Agreed that the best option looks like just fixing the pruning logic. Since we're talking about very few modes, and in the probe path (where reading edid takes 20ms easily) the additional cpu overhead really doesn't matter I think. -Daniel > Any other suggestions on this? > > Regards > -Ankit > > > > > > Perhaps this need to be handled in the test. > > > > > > -Regards, > > > > > > Ankit > > > > > > > > > On 4/6/2018 10:34 PM, Nautiyal, Ankit K wrote: > > > > From: "Sharma, Shashank" <shashank.sharma@xxxxxxxxx> > > > > > > > > Current DRM layer functions don't parse aspect ratio information > > > > while converting a user mode->kernel mode or vice versa. This > > > > causes modeset to pick mode with wrong aspect ratio, eventually > > > > causing failures in HDMI compliance test cases, due to wrong VIC. > > > > > > > > This patch adds aspect ratio information in DRM's mode conversion > > > > and mode comparision functions, to make sure kernel picks mode > > > > with right aspect ratio (as per the VIC). > > > > > > > > Background: > > > > This patch was once reviewed and merged, and later reverted due to > > > > lack of DRM cap protection. This is a re-spin of this patch, this > > > > time with DRM cap protection, to avoid aspect ratio information, when > > > > the client doesn't request for it. > > > > > > > > Review link: https://pw-emeril.freedesktop.org/patch/104068/ > > > > Background discussion: https://patchwork.kernel.org/patch/9379057/ > > > > > > > > Signed-off-by: Shashank Sharma <shashank.sharma@xxxxxxxxx> > > > > Signed-off-by: Lin, Jia <lin.a.jia@xxxxxxxxx> > > > > Signed-off-by: Akashdeep Sharma <akashdeep.sharma@xxxxxxxxx> > > > > Reviewed-by: Jim Bride <jim.bride@xxxxxxxxxxxxxxx> (V2) > > > > Reviewed-by: Jose Abreu <Jose.Abreu@xxxxxxxxxxxx> (V4) > > > > > > > > Cc: Ville Syrjala <ville.syrjala@xxxxxxxxxxxxxxx> > > > > Cc: Jim Bride <jim.bride@xxxxxxxxxxxxxxx> > > > > Cc: Jose Abreu <Jose.Abreu@xxxxxxxxxxxx> > > > > Cc: Ankit Nautiyal <ankit.k.nautiyal@xxxxxxxxx> > > > > > > > > V3: modified the aspect-ratio check in drm_mode_equal as per new flags > > > > provided by Ville. https://patchwork.freedesktop.org/patch/188043/ > > > > V4: rebase > > > > V5: rebase > > > > V6: As recommended by Ville, avoided matching of aspect-ratio in > > > > drm_fb_helper, while trying to find a common mode among connectors > > > > for the target clone mode. > > > > V7: rebase > > > > V8: rebase > > > > V9: rebase > > > > V10: rebase > > > > --- > > > > drivers/gpu/drm/drm_fb_helper.c | 12 ++++++++++-- > > > > drivers/gpu/drm/drm_modes.c | 35 ++++++++++++++++++++++++++++++++++- > > > > 2 files changed, 44 insertions(+), 3 deletions(-) > > > > > > > > diff --git a/drivers/gpu/drm/drm_fb_helper.c b/drivers/gpu/drm/drm_fb_helper.c > > > > index 0646b10..2ee1eaa 100644 > > > > --- a/drivers/gpu/drm/drm_fb_helper.c > > > > +++ b/drivers/gpu/drm/drm_fb_helper.c > > > > @@ -2183,7 +2183,11 @@ static bool drm_target_cloned(struct drm_fb_helper *fb_helper, > > > > for (j = 0; j < i; j++) { > > > > if (!enabled[j]) > > > > continue; > > > > - if (!drm_mode_equal(modes[j], modes[i])) > > > > + if (!drm_mode_match(modes[j], modes[i], > > > > + DRM_MODE_MATCH_TIMINGS | > > > > + DRM_MODE_MATCH_CLOCK | > > > > + DRM_MODE_MATCH_FLAGS | > > > > + DRM_MODE_MATCH_3D_FLAGS)) > > > > can_clone = false; > > > > } > > > > } > > > > @@ -2203,7 +2207,11 @@ static bool drm_target_cloned(struct drm_fb_helper *fb_helper, > > > > fb_helper_conn = fb_helper->connector_info[i]; > > > > list_for_each_entry(mode, &fb_helper_conn->connector->modes, head) { > > > > - if (drm_mode_equal(mode, dmt_mode)) > > > > + if (drm_mode_match(mode, dmt_mode, > > > > + DRM_MODE_MATCH_TIMINGS | > > > > + DRM_MODE_MATCH_CLOCK | > > > > + DRM_MODE_MATCH_FLAGS | > > > > + DRM_MODE_MATCH_3D_FLAGS)) > > > > modes[i] = mode; > > > > } > > > > if (!modes[i]) > > > > diff --git a/drivers/gpu/drm/drm_modes.c b/drivers/gpu/drm/drm_modes.c > > > > index d6133e8..454f2ff 100644 > > > > --- a/drivers/gpu/drm/drm_modes.c > > > > +++ b/drivers/gpu/drm/drm_modes.c > > > > @@ -1049,7 +1049,8 @@ bool drm_mode_equal(const struct drm_display_mode *mode1, > > > > DRM_MODE_MATCH_TIMINGS | > > > > DRM_MODE_MATCH_CLOCK | > > > > DRM_MODE_MATCH_FLAGS | > > > > - DRM_MODE_MATCH_3D_FLAGS); > > > > + DRM_MODE_MATCH_3D_FLAGS| > > > > + DRM_MODE_MATCH_ASPECT_RATIO); > > > > } > > > > EXPORT_SYMBOL(drm_mode_equal); > > > > @@ -1647,6 +1648,20 @@ void drm_mode_convert_to_umode(struct drm_mode_modeinfo *out, > > > > out->vrefresh = in->vrefresh; > > > > out->flags = in->flags; > > > > out->type = in->type; > > > > + > > > > + switch (in->picture_aspect_ratio) { > > > > + case HDMI_PICTURE_ASPECT_4_3: > > > > + out->flags |= DRM_MODE_FLAG_PIC_AR_4_3; > > > > + break; > > > > + case HDMI_PICTURE_ASPECT_16_9: > > > > + out->flags |= DRM_MODE_FLAG_PIC_AR_16_9; > > > > + break; > > > > + case HDMI_PICTURE_ASPECT_RESERVED: > > > > + default: > > > > + out->flags |= DRM_MODE_FLAG_PIC_AR_NONE; > > > > + break; > > > > + } > > > > + > > > > strncpy(out->name, in->name, DRM_DISPLAY_MODE_LEN); > > > > out->name[DRM_DISPLAY_MODE_LEN-1] = 0; > > > > } > > > > @@ -1693,6 +1708,24 @@ int drm_mode_convert_umode(struct drm_device *dev, > > > > strncpy(out->name, in->name, DRM_DISPLAY_MODE_LEN); > > > > out->name[DRM_DISPLAY_MODE_LEN-1] = 0; > > > > + /* Clearing picture aspect ratio bits from out flags, > > > > + * as the aspect-ratio information is not stored in > > > > + * flags for kernel-mode, but in picture_aspect_ratio. > > > > + */ > > > > + out->flags &= ~DRM_MODE_FLAG_PIC_AR_MASK; > > > > + > > > > + switch (in->flags & DRM_MODE_FLAG_PIC_AR_MASK) { > > > > + case DRM_MODE_FLAG_PIC_AR_4_3: > > > > + out->picture_aspect_ratio |= HDMI_PICTURE_ASPECT_4_3; > > > > + break; > > > > + case DRM_MODE_FLAG_PIC_AR_16_9: > > > > + out->picture_aspect_ratio |= HDMI_PICTURE_ASPECT_16_9; > > > > + break; > > > > + default: > > > > + out->picture_aspect_ratio = HDMI_PICTURE_ASPECT_NONE; > > > > + break; > > > > + } > > > > + > > > > out->status = drm_mode_validate_driver(dev, out); > > > > if (out->status != MODE_OK) > > > > return -EINVAL; > > > _______________________________________________ > > > Intel-gfx mailing list > > > Intel-gfx@xxxxxxxxxxxxxxxxxxxxx > > > https://lists.freedesktop.org/mailman/listinfo/intel-gfx > > > -- Daniel Vetter Software Engineer, Intel Corporation http://blog.ffwll.ch _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
