Hello, On Sunday, 18 March 2018 14:52:45 EET Rob Herring wrote: > On Fri, Mar 16, 2018 at 02:56:09PM +0530, Archit Taneja wrote: > > On Friday 16 March 2018 08:26 AM, Alexandru M Stan wrote: > > > Documentation for the optional backlight-pwm-passthru property. > > > Tells the EDP panel to folow the input pwm frequency instead > > > > s/folow/follow > > > > It would be nice if we could add the details you mentioned in > > patch #0 in either this or the next patch. > > > > > of generating its own. > > > > This is one of those bindings which is more a knob than a HW property, > > but I can't think of any easy way to figure this out in SW. So, I guess > > it's okay to have. > > > > One thing I was wondering about was whether this prop should belong to > > the eDP controller or the eDP panel. I don't have any strong opinion > > about it, though. > > Seems to me, it should be the panel. It's a setting in the panel, right? As this aims at fixing an issue with the panel, I agree it should be a panel property. Stupid question (I'm not too familiar with eDP panels), couldn't we set EDP_BACKLIGHT_FREQ_PWM_PIN_PASSTHRU unconditionally ? > Is this generic to DP panels or something specific to a certain panel? > The naming (vendor prefix or not) and doc location should match > whatever the answer to that is. > > > Reviewed-by: Archit Taneja <architt@xxxxxxxxxxxxxx> > > > > Thanks, > > Archit > > > > > Signed-off-by: Alexandru M Stan <amstan@xxxxxxxxxxxx> > > > --- > > > > > > Documentation/devicetree/bindings/display/bridge/analogix_dp.txt | 4 > > > ++++ > > > 1 file changed, 4 insertions(+) > > > > > > diff --git > > > a/Documentation/devicetree/bindings/display/bridge/analogix_dp.txt > > > b/Documentation/devicetree/bindings/display/bridge/analogix_dp.txt > > > index 0c7473dd0e51..3c15242f6ce3 100644 > > > --- a/Documentation/devicetree/bindings/display/bridge/analogix_dp.txt > > > +++ b/Documentation/devicetree/bindings/display/bridge/analogix_dp.txt > > > > > > @@ -23,6 +23,10 @@ Required properties for dp-controller: > > > from general PHY binding: Should be "dp". > > > > > > Optional properties for dp-controller: > > > + -backlight-pwm-passthru: > > > + Directly pass the PWM frequency applied to the BL_PWM_DIM > > > + pin to the backlight current source. Done via > > > + EDP_BACKLIGHT_MODE_SET_REGISTER on DPCD. > > > > > > -force-hpd: > > > Indicate driver need force hpd when hpd detect failed, this > > > is used for some eDP screen which don't have hpd signal. -- Regards, Laurent Pinchart _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
