Il 21/02/2018 13:57, Maxime Ripard ha scritto:
In the case where mode_valid callback of our RGB connector was called
before mode_set was being called, the range of dividers would not be set,
resulting in a division by zero later on in the clk_round_rate logic.
Set the range of dividers before calling clk_round_rate to fix this.
Signed-off-by: Maxime Ripard <maxime.ripard@xxxxxxxxxxx>
Tested-by: Giulio Benetti <giulio.benetti@xxxxxxxxxxxxxxxx>
Before crtc couldn't be added because of min=0 and max=0.
Now they're initiliazed and crtc is added correctly.
---
drivers/gpu/drm/sun4i/sun4i_rgb.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/gpu/drm/sun4i/sun4i_rgb.c b/drivers/gpu/drm/sun4i/sun4i_rgb.c
index 832f8f9bc47f..b8da5a50a61d 100644
--- a/drivers/gpu/drm/sun4i/sun4i_rgb.c
+++ b/drivers/gpu/drm/sun4i/sun4i_rgb.c
@@ -92,6 +92,8 @@ static int sun4i_rgb_mode_valid(struct drm_connector *connector,
DRM_DEBUG_DRIVER("Vertical parameters OK\n");
+ tcon->dclk_min_div = 6;
+ tcon->dclk_max_div = 127;
rounded_rate = clk_round_rate(tcon->dclk, rate);
if (rounded_rate < rate)
return MODE_CLOCK_LOW;
--
Giulio Benetti
CTO
MICRONOVA SRL
Sede: Via A. Niedda 3 - 35010 Vigonza (PD)
Tel. 049/8931563 - Fax 049/8931346
Cod.Fiscale - P.IVA 02663420285
Capitale Sociale € 26.000 i.v.
Iscritta al Reg. Imprese di Padova N. 02663420285
Numero R.E.A. 258642
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
