On Sun, Nov 06, 2011 at 04:03:21PM +0100, Tormod Volden wrote:
> From: Tormod Volden <debian.tormod@xxxxxxxxx>
>
> Some cards report that they support only 4x, in which case they
> should support 2x and 1x as well, according to the AGP spec.
Have you tested it on other hardware besides your KN133?
>
> Otherwise a requested 1x or 2x rate will result in 0 being set:
>
> agpgart-via 0000:00:00.0: putting AGP V2 device into 0x mode
>
> For instance ProSavage KN133 [5333:8d02] only reports 4x.
>
> Signed-off-by: Tormod Volden <debian.tormod@xxxxxxxxx>
> ---
> drivers/char/agp/generic.c | 18 ++++++++++++++++++
> 1 files changed, 18 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/char/agp/generic.c b/drivers/char/agp/generic.c
> index b072648..c5d04e5 100644
> --- a/drivers/char/agp/generic.c
> +++ b/drivers/char/agp/generic.c
> @@ -526,6 +526,24 @@ static void agp_v2_parse_one(u32 *requested_mode, u32 *bridge_agpstat, u32 *vga_
> break;
> }
>
> + /* Some graphic cards report they only support 4x, however the AGP 2.0 spec
> + * (section 4.1.1) says components must support the lower speeds as well.
> + */
> + switch (*vga_agpstat & 7) {
> + case 4:
> + *vga_agpstat |= (AGPSTAT2_2X | AGPSTAT2_1X);
> + printk(KERN_INFO PFX "Graphics card claims to only support x4 rate. "
> + "Fixing up support for x2 & x1\n");
> + break;
> + case 2:
> + *vga_agpstat |= AGPSTAT2_1X;
> + printk(KERN_INFO PFX "Graphics card claims to only support x2 rate. "
> + "Fixing up support for x1\n");
> + break;
> + default:
> + break;
> + }
> +
> /* Check the speed bits make sense. Only one should be set. */
> tmp = *requested_mode & 7;
> switch (tmp) {
> --
> 1.7.5.4
>
> _______________________________________________
> dri-devel mailing list
> dri-devel@xxxxxxxxxxxxxxxxxxxxx
> http://lists.freedesktop.org/mailman/listinfo/dri-devel
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/dri-devel
