Re: [PATCH 0/4] Move DP phy switch to PHY driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Doug

Thank you for mentioning this patch.

I think the focus of the discussion is: can we put the grf control bit to dts.

The RK3399 has 2 Type-C phy, but only one DP controller, this "uphy_dp_sel"

can help to switch these 2 phy. So I think this bit can be considered as a part of

Type-C phy, these 2 phy have different bits, just similar to other bits (such as "pipe-status").

Put them to DTS file might be a accepted practice.



On 2017年11月29日 07:32, Doug Anderson wrote:
Hi,

On Thu, Feb 9, 2017 at 11:44 PM, Chris Zhong <zyw@xxxxxxxxxxxxxx> wrote:
There are 2 Type-c PHYs in RK3399, but only one DP controller. Hence
only one PHY can connect to DP controller at one time, the other should
be disconnected. The GRF_SOC_CON26 register has a switch bit to do it,
set this bit means enable PHY 1, clear this bit means enable PHY 0.

If the board has 2 Type-C ports, the DP driver get the phy id from
devm_of_phy_get_by_index, and then control this switch according to
this id. But some others board only has one Type-C port, it may be PHY 0
or PHY 1. The dts node id can not tell us the correct PHY id. Hence move
this switch to PHY driver, the PHY driver can distinguish between PHY 0
and PHY 1, and then write the correct register bit.



Chris Zhong (4):
   Documentation: bindings: add uphy-dp-sel for Rockchip USB Type-C PHY
   arm64: dts: rockchip: add rockchip,uphy-dp-sel for Type-C phy
   phy: rockchip-typec: support DP phy switch
   drm/rockchip: cdn-dp: remove the DP phy switch

  Documentation/devicetree/bindings/phy/phy-rockchip-typec.txt | 5 +++++
  arch/arm64/boot/dts/rockchip/rk3399.dtsi                     | 2 ++
  drivers/gpu/drm/rockchip/cdn-dp-core.c                       | 7 -------
  drivers/phy/phy-rockchip-typec.c                             | 9 +++++++++
  4 files changed, 16 insertions(+), 7 deletions(-)
What ever happened to this series?  It seemed like it just dropped on
the floor...

There was a bit of contention on patch #3
<https://patchwork.kernel.org/patch/9566095/> about the fact that we
were specifying addresses in the device tree vs. hardcoding them in
the driver.  Any way we can just make a decision and go with it?


-Doug




--
Chris Zhong


_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel




[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux