After reset assertion, we only have to wait for the reset signals to propagate through the GPU before deasserting the reset again. A few hundred clock cycles should be more than enough. Replace the msleep(1), which can actually take about 30 ms on i.MX6Q in some configurations, with an usleep_range of a few microseconds. If the delay was too short, the FE would not be idle afterwards, and the reset would be retried. Signed-off-by: Philipp Zabel <p.zabel@xxxxxxxxxxxxxx> --- drivers/gpu/drm/etnaviv/etnaviv_gpu.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/gpu/drm/etnaviv/etnaviv_gpu.c b/drivers/gpu/drm/etnaviv/etnaviv_gpu.c index fc9a6a83dfc77..9f7999552cc31 100644 --- a/drivers/gpu/drm/etnaviv/etnaviv_gpu.c +++ b/drivers/gpu/drm/etnaviv/etnaviv_gpu.c @@ -461,7 +461,7 @@ static int etnaviv_hw_reset(struct etnaviv_gpu *gpu) gpu_write(gpu, VIVS_HI_CLOCK_CONTROL, control); /* wait for reset. */ - msleep(1); + usleep_range(10, 20); /* reset soft reset bit. */ control &= ~VIVS_HI_CLOCK_CONTROL_SOFT_RESET; -- 2.11.0 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
