* Tomi Valkeinen <tomi.valkeinen@xxxxxx> [170511 01:37]: > On 10/05/17 21:29, Tony Lindgren wrote: > > * Tomi Valkeinen <tomi.valkeinen@xxxxxx> [170510 10:44]: > >> > >> > >> On 10/05/17 19:46, Tony Lindgren wrote: > >>> * Tomi Valkeinen <tomi.valkeinen@xxxxxx> [170510 00:26]: > >>>> On 09/05/17 18:05, Sebastian Reichel wrote: > >>>> > >>>>> patch 10: > >>>>> I think dsi pin muxing should be done by providing pinmux > >>>>> info via DT. > >>>> > >>>> Unfortunately there's no pinmux driver for the kind of register we have > >>>> for DSI. At least this was the case not that long ago. > >>> > >>> What are the TRM names for the registers you need to mux? > >> > >> CONTROL_DSIPHY > > > > Oh just one register with few bits? That should be doable in > > dts with pinctrl-single,bit-per-mux and pinctrl-single,bits. > > No, I don't think it works. Or at least I can't figure out how. > > pinctrl-single doesn't allow to freely set the bits, but requires the > pins to have similar bit structure (function-mask). In CONTROL_DSIPHY, > DSI1 and DSI2 have different bit structures. OK if the register mixes different types of controllers that can't be partitioned into separate 8 or 16 bit instances then you're out of luck with pinctrl-single. If it does not fit, no point trying to force it, then you need a custom pinctrl driver. > I don't understand why pinctrl-single tries so hard to fit things into > one mold... Basically on many SoCs pinctrl is just the same exact control register repeated for each pin on the SoC: $ git grep '"pinctrl-single"' arch/arm*/boot/dts | sort | uniq | wc -l 20 Regards, Tony _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
