Hi, I observe very strange behavior dependent on value of CONFIG_DRM_RADEON parameter. When it's set to m everything works very good, no problem. When I set it to y I see kernel hang during boot. Or I should better say it "almost hangs" because during last boot attempt I accidentally waited a little bit longer and saw that after more than a minute waiting system continued to boot. Dmesg after "hang" shows these messages: [ 8.542639] [drm] Loading CEDAR Microcode [ 69.161605] r600_cp: Failed to load firmware "radeon/CEDAR_pfp.bin" [ 69.161670] [drm:evergreen_startup] *ERROR* Failed to load firmware! While during normal boot [ 9.898870] [drm] Loading CEDAR Microcode [ 9.908425] radeon 0000:05:00.0: WB enabled Is this a bug? I'm seeing this on 3.1-rc3. Full dmesgs for both boots are attached. Pavel
Attachment:
dmesg.module
Description: Binary data
Attachment:
dmesg.built-in
Description: Binary data
_______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel