From: Mihail Atanassov <mihail.atanassov@xxxxxxx> The rate of mclk depends on the use-case. If no downscaling is required, then mclk == pxlclk is a valid option; with downscaling however, the rate at which mclk runs determines how much a plane can be downscaled before composition. This is a system integration + power management issue that is more suited to firmware rather than this driver. Signed-off-by: Mihail Atanassov <mihail.atanassov@xxxxxxx> Signed-off-by: Liviu Dudau <Liviu.Dudau@xxxxxxx> --- drivers/gpu/drm/arm/malidp_crtc.c | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-) diff --git a/drivers/gpu/drm/arm/malidp_crtc.c b/drivers/gpu/drm/arm/malidp_crtc.c index 08e6a71f5d05..294b53697334 100644 --- a/drivers/gpu/drm/arm/malidp_crtc.c +++ b/drivers/gpu/drm/arm/malidp_crtc.c @@ -63,8 +63,7 @@ static void malidp_crtc_enable(struct drm_crtc *crtc) clk_prepare_enable(hwdev->pxlclk); - /* mclk needs to be set to the same or higher rate than pxlclk */ - clk_set_rate(hwdev->mclk, crtc->state->adjusted_mode.crtc_clock * 1000); + /* We rely on firmware to set mclk to a sensible level. */ clk_set_rate(hwdev->pxlclk, crtc->state->adjusted_mode.crtc_clock * 1000); hwdev->modeset(hwdev, &vm); -- 2.11.1 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
