According to the PHY IP core vendor, the SVSRET signal must be asserted
before resetting the PHY. Tests on RK3288 and R-Car Gen3 showed no
regression, the change should thus be safe.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@xxxxxxxxxxxxxxxx>
Reviewed-by: Jose Abreu <joabreu@xxxxxxxxxxxx>
---
drivers/gpu/drm/bridge/dw-hdmi.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/gpu/drm/bridge/dw-hdmi.c b/drivers/gpu/drm/bridge/dw-hdmi.c
index 93e8816f1f78..4fda0717e789 100644
--- a/drivers/gpu/drm/bridge/dw-hdmi.c
+++ b/drivers/gpu/drm/bridge/dw-hdmi.c
@@ -986,6 +986,10 @@ static int hdmi_phy_configure(struct dw_hdmi *hdmi, int cscon)
/* gen2 pddq */
dw_hdmi_phy_gen2_pddq(hdmi, 1);
+ /* Leave low power consumption mode by asserting SVSRET. */
+ if (hdmi->phy->has_svsret)
+ dw_hdmi_phy_enable_svsret(hdmi, 1);
+
/* PHY reset. The reset signal is active high on Gen2 PHYs. */
hdmi_writeb(hdmi, HDMI_MC_PHYRSTZ_PHYRSTZ, HDMI_MC_PHYRSTZ);
hdmi_writeb(hdmi, 0, HDMI_MC_PHYRSTZ);
@@ -1028,11 +1032,7 @@ static int hdmi_phy_configure(struct dw_hdmi *hdmi, int cscon)
dw_hdmi_phy_gen2_txpwron(hdmi, 1);
dw_hdmi_phy_gen2_pddq(hdmi, 0);
- /* The DWC MHL and HDMI 2.0 PHYs need the SVSRET signal to be set. */
- if (hdmi->phy->has_svsret)
- dw_hdmi_phy_enable_svsret(hdmi, 1);
-
- /*Wait for PHY PLL lock */
+ /* Wait for PHY PLL lock */
msec = 5;
do {
val = hdmi_readb(hdmi, HDMI_PHY_STAT0) & HDMI_PHY_TX_PHY_LOCK;
--
Regards,
Laurent Pinchart
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
