On 11.01.2017 07:33, Hoegeun Kwon wrote:
> The Samsung s6e3ha2 is a 5.7" 1440x2560 AMOLED panel connected
> using MIPI-DSI interfaces.
>
> Signed-off-by: Donghwa Lee <dh09.lee@xxxxxxxxxxx>
> Signed-off-by: Hyungwon Hwang <human.hwang@xxxxxxxxxxx>
> Signed-off-by: Hoegeun Kwon <hoegeun.kwon@xxxxxxxxxxx>
> Tested-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
> Reviewed-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx>
> ---
> .../bindings/display/panel/samsung,s6e3ha2.txt | 26 ++++++++++++++++++++++
> 1 file changed, 26 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/display/panel/samsung,s6e3ha2.txt
>
> diff --git a/Documentation/devicetree/bindings/display/panel/samsung,s6e3ha2.txt b/Documentation/devicetree/bindings/display/panel/samsung,s6e3ha2.txt
> new file mode 100644
> index 0000000..3e7892c
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/display/panel/samsung,s6e3ha2.txt
> @@ -0,0 +1,26 @@
> +Samsung S6E3HA2 5.7" 1440x2560 AMOLED panel
> +
> +Required properties:
> + - compatible: "samsung,s6e3ha2"
> + - reg: the virtual channel number of a DSI peripheral
> + - vdd3-supply: I/O voltage supply
> + - vci-supply: voltage supply for analog circuits
> + - reset-gpios: a GPIO spec for the reset pin (active low)
> + - enable-gpios: a GPIO spec for the panel enable pin (active high)
> + - te-gpios: a GPIO spec for the tearing effect synchronization signal
> + gpio pin (active high)
One more thing I didn't catch earlier, te-gpios property should be
optional - in case of hw-trigger we do not need it.
Regards
Andrzej
> +
> +Example:
> +&dsi {
> + ...
> +
> + panel@0 {
> + compatible = "samsung,s6e3ha2";
> + reg = <0>;
> + vdd3-supply = <&ldo27_reg>;
> + vci-supply = <&ldo28_reg>;
> + reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
> + enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
> + te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
> + };
> +};
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
