Hi Laurent, Sorry for the delayed answer but I am quite busy at the moment. On 06-01-2017 01:48, Laurent Pinchart wrote: [snip] >>>> The TX_READY signal is documented in the i.MX6 datasheet as being a PHY >>>> output signal, but there seems to be no HDMI TX register from which its >>>> state can be read. Do I need to poll the HDMI_PHY_PTRPT_ENBL register >>>> through I2C ? How long is the PHY expected to take to set TX_READY to 0 >>>> ? >>> TX_READY can be read from register 0x1A of phy, BIT(2) (through >>> I2C). >> That's what I thought, I'll poll that then. Do you have any idea how long >> it's supposed to take, to set an appropriate timeout ? For 3d tx phy and for 25 MHz input reference clock the power-up time is ~1ms, there is no data in the docs to power-down time but it should be similar. Reference clock value is board dependent and the minimum value for HDMI shall be 13.5MHz. > On i.MX6 (3D TX PHY) register 0x1a reads as 0x0007 before powering down the > PHY (by deasserting TXPWRON) and as 0x0000 immediately after. On RK3288 (MHL > PHY) the register reads as 0x0207 and as 0x0000 immediately after deasserting > TXPWRON. It seems that one I2C read is a sufficient delay for TX_READY to go > low. >>> Not sure if same offset for all phys though. >> Most probably not, it would be too easy :-) I'll investigate (which will >> likely include lots of guesswork). If you can find any information about >> that (and especially about the MHL and HDMI 2.0 PHYs) that would be very >> appreciated, as I don't have access to any documentation that mentions a >> TX_READY bit for those. > I haven't tested the HDMI 2.0 PHY yet, but I'd be surprised if the TX_READY > bit was in the same register at the same position. > The info I got the register offset is from an HDMI 2.0 phy :) Notice that there are a lot of phy versions and some of them (used in dw-hdmi) maybe customized, I don't think I have access to that custom phys documentation. Please test the HDMI 2.0 phy and check if the register is the same, it should be. In the meantime it would really be helpful if some of the developers that used dw-hdmi supplied this info about the registers as they should know exactly what phy was used. Best regards, Jose Miguel Abreu _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
