On Thu, Oct 20, 2016 at 11:43:37AM +0800, Chen-Yu Tsai wrote: > Some rgb-to-vga bridges have an enable GPIO, either directly tied to > an enable pin on the bridge IC, or indirectly controlling a power > switch. > > Add support for it. > > Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx> > --- > .../bindings/display/bridge/dumb-vga-dac.txt | 2 ++ > drivers/gpu/drm/bridge/dumb-vga-dac.c | 28 ++++++++++++++++++++++ > 2 files changed, 30 insertions(+) > > diff --git a/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt b/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt > index 003bc246a270..d3484822bf77 100644 > --- a/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt > +++ b/Documentation/devicetree/bindings/display/bridge/dumb-vga-dac.txt > @@ -16,6 +16,8 @@ graph bindings specified in Documentation/devicetree/bindings/graph.txt. > - Video port 0 for RGB input > - Video port 1 for VGA output > > +Optional properties: > +- enable-gpios: GPIO pin to enable or disable the bridge This should also define the active state. > +static void dumb_vga_enable(struct drm_bridge *bridge) > +{ > + struct dumb_vga *vga = drm_bridge_to_dumb_vga(bridge); > + > + if (vga->enable_gpio) > + gpiod_set_value_cansleep(vga->enable_gpio, 1); So the driver should allow either active high or low. > +} > + > +static void dumb_vga_disable(struct drm_bridge *bridge) > +{ > + struct dumb_vga *vga = drm_bridge_to_dumb_vga(bridge); > + > + if (vga->enable_gpio) > + gpiod_set_value_cansleep(vga->enable_gpio, 0); > +} > + _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel