On 2016-06-23 17:59, Jon Hunter wrote: > The I2C driver core for boards using device-tree assumes any subnode of > an I2C adapter in the device-tree blob as being a I2C slave device. > Although this makes complete sense, some I2C adapters may have subnodes > which are not I2C slaves but subnodes presenting other features. For > example some Tegra devices have an I2C interface which may share its > pins with other devices and to share these pins subnodes for > representing these pins so they have be shared via the pinctrl framework > are needed. > > To allow I2C adapters to have non-I2C specific subnodes in device-tree > that are not parsed by the I2C driver core by adding support for a > 'i2c-bus' subnode where I2C slaves can be placed. If the 'i2c-bus' > subnode is present then all I2C slaves must be placed under this subnode. > > Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx> > Acked-by: Thierry Reding <treding@xxxxxxxxxx> > --- > Documentation/devicetree/bindings/i2c/i2c.txt | 8 ++++++++ > 1 file changed, 8 insertions(+) > > diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt b/Documentation/devicetree/bindings/i2c/i2c.txt > index f31b2ad1552b..71bea55d4c1b 100644 > --- a/Documentation/devicetree/bindings/i2c/i2c.txt > +++ b/Documentation/devicetree/bindings/i2c/i2c.txt > @@ -32,6 +32,14 @@ wants to support one of the below features, it should adapt the bindings below. > - clock-frequency > frequency of bus clock in Hz. > > +- i2c-bus > + For I2C adapters that have child nodes that are a mixture of both I2C > + devices and non-I2C devices (such as a pin controller), the 'i2c-bus' > + subnode can be used for populating I2C devices. If the 'i2c-bus' > + subnode is present, only subnodes of this will be considered as I2C > + slaves. The properties, '#address-cells' and '#size-cells' must be > + defined under this subnode if present. Hmmm, those #-properties are listed above, under "Required properties", which is no longer 100% true. Maybe rephrase to slaves. The required properties '#address-cells' and '#size-cells' must be defined under this subnode instead, if this subnode is present. to make the rules (even) clearer? Cheers, Peter > + > - i2c-scl-falling-time-ns > Number of nanoseconds the SCL signal takes to fall; t(f) in the I2C > specification. > _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel